answersLogoWhite

0


Best Answer

The front bumper skirt must be removed first. There are a couple of bolts on each side just forward of the front tires. Then there are several plastic push fasteners across the top under the hood. Once the skirting is removed the battery can be seen just forward of the Left front tire. Good luck.

All that needs removed is the inner fender liner in front of the driver side wheel. You can then access the battery.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the battery in a 2001 Chrysler Sebring convertible?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Dead battery in 1997 Chrysler Sebring convertible?

Charge it, test it, replace it.


How do you replace the starter on a 2001 Chrysler Sebring convertible?

Remove the positive battery cable from your 2001 Chrysler Sebring battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


When to replace the Timing belt in a 1997 Chrysler Sebring convertible jxi?

100,000 miles


DO you have to drop the fuel tank on a 1999 Chrysler Sebring convertible to replace the fuel pump?

Yes


When should you replace the timing belt on a 1999 Chrysler Sebring JXi Convertible?

100,000 miles


How do you replace windshield washer pump Chrysler sebring convertible?

The windshield washer pump on a Chrysler Sebring convertible is replaced by disconnecting the wiring harness and unbolting the pump. It can then be lifted from its mounting bracket and a new pump put into place.


How do you replace the transmission solenoid pack on a 1998 Chrysler Sebring Convertible?

To replace the transmission solenoid pack on a 1998 Chrysler Sebring, remove the air filter box, the battery, and the battery tray. Remove the 4 bolts on the frame and the trans cooler lines. The solenoid pack is screwed to the to the transmission with 3 10 mm bolts. Remove the solenoid pack and replace it.?æ


How do you replace the alternator in a 2000 Chrysler Sebring convertible?

When replacing the alternator on a 2000 Chrysler Sebring convertible begin by removing the belt. Next, remove the wiring. Lastly, remove the retaining bolts. Reverse the process to install the new alternator.


Can you replace a 2.7L engine in a 2002 Chrysler Sebring convertible with a 3.0L from a same year Chrysler Sebring coupe?

It is not a direct swap. They use different transmissions, computers, wiring, etc.


How long should labor take to replace a water pump in a 1996 Chrysler Sebring Convertible?

6 hours


Why wont your 2004 Chrysler sebring start up after you replace the battery?

Because you didn't charge the battery.


How do you replace the battery on a 1998 Chrysler sebring jxi convertible?

The battery is in the front of the left front tire well. The manual says you don't have to take off the tire, but you DO. Remove a few screws at the front of the wheel well and you'll find the battery.