0
How do you replace the front turn signal bulb located on a 2004 Chrysler Sebring?
Wiki User
∙ 8y ago
Bulbs are covered by the factory for Chrysler for 12 months or 12000 miles. If this 2004 does not qualify then to change the front bulb, remove the 2 screws that hold the lens in and pull the headlight housing out enough to reach behind and twist the bulb out. For the rear, open the trunk, remove all the plastic wing nuts, pull the lens out away from the body.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
Why do the turn signals not work in a 2004 Chrysler Sebring?
If the bulbs and fuse are good, replace the turn signal Flasher Relay.
How do you replace the turn signal flasher on a 1997 Chrysler Sebring?
OPen the trunk or hood, pull out the panel and replace the bulb... If that doesnt work, check your fuses
Where is the 2004 Chrysler Sebring multi-function switch?
Turn signal headlamp switch
Where is the flasher unit located on a 1996 Chrysler Sebring convertible?
It is located on the side of the radio between the glove box and the radio if you turn the turn signal on you will feel it flash if you can't here it.
Where is the speedometer cable located in a 2003 chrysler sebring?
The speedometer signal is all electronic. There is no cable. The signal comes from speed sensors.The speedometer signal is all electronic. There is no cable. The signal comes from speed sensors.
What side of the steering wheel is the signal light pole on a Chrysler Sebring in the United States?
The turn signal switch is on the left.The turn signal switch is on the left.
Why does the right hand turn signal on a 2006 Chrysler Sebring flash faster than the left hand signal when activated?
You have a failed bulb on the right side.
Where is the turn signal control relay located on a 1998 Chrysler Sebring Coupe?
I have a turn signal light that keeps flashing regardless of the control arm position. I think that the problem is in the turn signal control relay but I don't know where it is located. I did find the 3 prong relay located behind the center console but this is not the problem because I replaced it and have the same problem.
Where is the multi function switch on a 2001 Chrysler Sebring?
The multifunction switch is the turn signal switch and whatever else is part of it.
What is wrong if a 1996 Chrysler Sebring computer reads 'cam position sensor no signal'?
There is a problem with the cam sensor or the wiring to it.
Where is the switch for fog lamps located on a 1997 Chrysler Sebring?
Pull the end of the turn signal lever out about 1/8th inch. This only works with the lights on. Fog lamps will not work with headlights off.
What is the meaning of the P1391 code 98 Chrysler sebring convertible?
1391 is for an intermittent loss of the cam sensor or crank sensor signal
