Hi, I believe the 92 was the last year with the "sleepy eyes", the automatic headlight cover doors. Changing a headlight is very simple although it has to be done with the headlights on (unless you have a way to open the doors without the headlights being on). However, it's relatively easy and quick although bright. Each headlight has a metal frame around it (usually black). They have four Phillips head screws that hold the headlight in place. Remove the frame and the headlight will dangle from the wire harness. Just unplug the harness, should be a three prong harness which should match the three prongs on the back of the new light. Plug it in and screw the frame back on and you're good to go.
rtalk7
It is located in the Fuel Tank which means the Tank will need to be dropped in order to replace the Pump.
That'll be a bulb from inside the engine compartment, behind the lamp.
Depends on the year, but on mine there are 2 large bolts above each headlight housing on the top sill of the front of the car where the hood closes over them. They look like they would hold the sill to the car, but they hold a large metal headlight assembly. Remove the 2 bolts, the housing will slide forward and then you can remove the bulbs.
its on the same part where you turn them on i went to the junk yard and got the whole thing dash piece and all for $5
The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.
Front or rear.. disc or drum type..??????????
be more specific.. replace pads..?? replace hose..?? repair master cylinder..??
you might need to replace the hinge pins.. or the complete hinge
if theyre cracked or broken you need to replace em.. plenty on eBay startin at under a 10er.. if they just dull.. buy a cleanin kit from the local autoshop for under a 5er..
If you just want to change the bulb,you might be able to reach your hand behind the headlight and twist the locking ring counterclockwise and remove the bulb.you may need to unbolt the headlight housing to make room to replace it.
ffs.. it ain't rocket surgery.. follow the instructions on the box
Hi, assuming your Lebaron has the 3.0 engine, the pcv valve is located right behind the valve cover that faces you looking at the engine. It's toward the right side. It's threaded into the block and there will be a black tube coming out of it. Very easy to remove and replace. rtalk7