First you must make sure that the car is a little cool. then you must drain out the antifreeze that is in the system. Remove the hose that connects to the radiator. Then on the fan that is between the radiator and the engine you must remove the screws that hold it in place. then disconnect the hoses that are on the bottom left-hand side if your are facing the car. Then there are also connectors that are from the radiator that are connected to the actual car that need to be disconnected. Make sure that fan is totally disconnected from the radiator. then pull out the radiator. When you put the new radiator in make sure that your are not caught on anything. then put the screws back in that hold the radiator in place. then out the hoses on in the correct spot and make sure that YOU PUT THE CLAMPS ON THE HOSE IN THE EXACT SAME PLACE AS THEY WERE BEFORE otherwise you will have a slow leak and the engine will overheat. Then put the clamp back on the top of the radiator (NOTE: IF THE AFTERMARKET RADIATOR IS TOO BIG THE ORIGINAL CLAMP WILL NOT FIT OVER THE NEW RADIATOR. SO YOU WILL NEED TO CUT OFF THE BRACKET THAT IS IN THE WAY WHICH IS THE PIECE CLOSER TO YOU IF YOU ARE LOOKING AT IT. CUT OFF WITH A DREMEL OR SOMETHING.) then put antifreeze in the radiator itself and then when you cannot put anymore start the car with the cap off and it will go down. then pour more antifreeze till it is full. MAKE SURE THAT YOU HAVE ENOUGH ANTIFREEZE.IT MIGHT TAKE A WHILE TILL ALL THE ANTIFREEZE IS FULLY REPLACED. and that is how you replace a radiator.
to replace the radiator you will have to remove the front clip of the car and the air intake box i replaced mine it took me around 8 hours.. yeah me too. lot's of fun!
how toreplace radiator in a 2001 honda accord ex four cylinder
If this radiator has a plastic top, I would suggest you purchase a new radiator. If it is metal, then remove the radiator and have it repaired and flushed, at a radiator shop. This is a good time to service your cooling system. Replace the thermostat and flush the engine out. Check all radiator hoses including the heater hoses, and replace if necessary. Reinstall a 50/50 mix of the appropriate coolant. Don't forget to bleed the air out of the system after reinstalling everything.
Four cylinder, under the housing where the upper radiator hose attaches. Six cylinder, under the housing where the lower radiator hose attaches to the engine.
2002 ford explorer xls 6 cylinder labor radiator cost
Replace, flush, or repair, depending on what the problem is.
With the correct tools and lots of patience.
If you are getting exhaust smoke coming out of the radiator overflow, you need to replace the head gasket that seals the cylinder from the cylinder cap where your coolant runs through to cool the engine.
Try to replace only bearing #6203 2Z inside of pulley.
If you have a 4-cylinder, about 20 minutes. 90 minutes if you have the V6.
follow upper radiator hose to motor
There are fourteen steps on how to replace the water pump in a 2004 Jeep Liberty Sport 2.4 liter 4 cylinder. Some of the step-by-step instructions are set the drain pan underneath the radiator's drain plug, drain the radiator, and then use a wrench to twist the radiator plug counterclockwise.