get on driver seat & look for two things.
1st: Check button (located on indicator stick)
2nd: reset button (small black stick button located on left side of the speedometer)
Move the key to the ON position where all the lights turns ON but the car doesn't start. Push & hold the reset button until you see the service icon appears. Now press the check button couple of times until you see the brake fluid icon. Once the brake fluid icon appears press & hold the reset button again until the RESET icon appears. As soon RESET icon appears press & hold the reset button again until you see the new milage.
how do you reset brake warning light 0n 745li bmw
check your brake fluid level and fill with brake fluid to the top of the master cylinder reservoir.
You don't. Just and fluid and it will go off.
If your brake light is on that inducates that your brake fluid level in the brake master cylinder in your engine compartment is LOW ( assuming that your emergency brake isn't on ) Having a low brake fluid level will also turn on your ABS light
Check Brake fluid level in master cylinder and make sure Emergency brake is fully released
Have you checked the brake fluid level in your brake master cylinder in your engine compartment ? a low level will turn on your brake light in the dash
low on brake fluid top off
Change the brake pads sensors. You must change them after every brake pad swap.
The brake fluid reservoir
You can't reset the parking light - It shows you have a fault at that time - Cure the fault and the light will go out - I have a problem with mine - I have an intermittent fault the light only comes on when the parking brake is faulty - most of the time the lights out
Where is the brake fluid filler located on a 2004 Toyota Corolla?
A 2004 Jeep Liberty uses DOT 3 brake fluid.