How do you reset password on sears key pad with no enter key model 53671 garage door opener?

Answer 1

If this doesn't work for you. Here is what I just did on my older model Sears garage door opener with ("NO ENTER BUTTON" on the keypad) and it worked perfectly. 1). Unplug the unit from the ceiling plug or where ever it's plugged into. 2). If you have a large wired button to open the garage door (about 5" x 3") remove it from the wall and flip it around to expose the underside of the unit. Remove the 3 screws carefully that hold the circuit board to the casing remembering where they go when you reconnect them. Two of them should have wires attached to them. 3). replace the 9 volt battery and locate PROGRAM / OPERATE switch and place it in the "PROGRAM" mode. Go to the keypad and enter you choice of 4 numbers. 4). place the switch back to "OPERATE" mode, replace the 3 screws to their original terminals, mount back on the wall, plug in the opener to the ceiling plug and you should be good to go. After 12 years of living at this house and never having access to the keypad was bothering me. I finally figured it out. I hope this helps someone in the same position Good luck