You should ensure that you have had any needed repairs done to your vehicle when the check engine light comes on. If you have an ODB reader and already performed the repairs, you can use it to reset the check engine light, otherwise it can take time after a series of cold starts, and a mix of city and highway driving for the system to reset itself.
To turn off the check engine, disconnect the positive battery cable for 30 seconds, then reconnect.
To reset the check engine light you must have an OBDII code reader with the reset function. The underlying fault that caused the light to turn on must be fixed or the light will turn on again once the condition is detected. The light will be reset if the battery is disconnected for about 10 minutes but will turn on again if the fault that caused the light to turn on is not fixed. Also, the engine will not run at its best until the computer is retrained.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
Remove battery cable, reattach first step.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.
how do i reset the check engine light on a 1999 acura 3.2tl
hoe do you reset the check engine light in a 1995 land rover
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
You need a scan tool to properly reset the check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?
There is no reset button for the check engine light. It must be reset with an OBD scan tool.