With the key in the ingnition and either acc or start position (engine not running) pull the fog light switch out and then back in 3 times, you should then hear a beeb to let you know it reset. Might have to do it a couple of times until you hear the beeb.
You have to have a computer programmer module, from O'Reily's or Autozone to reset it. Some will let you do it and some say that they are not authorized to do it. Good luck...
The light is on because there is a problem with the system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself after a short drive.
unhook a battery cable for about 3 minutes and re-hook.
No.
Take it to a mechanic, and have them erase the codes. Auto zone and advance will not do it as they are not mechanics
you eat 25 corndogs ! :]
Unhook the car battery.
There are no insturctions in the manual. I did find that once coolant was added it went off. My just came on again and after awhile it went off. I am troubleshooting now. My problem is either a bad sensor or it could possible be low in the resevoir. I have yet to check. If you still have the light I suggest to take it in for repair.
how do I set reset ignition security on a 1999 z34 monte carlo
General Motors cars do not have a reset switch.
RESET THE ALARM
No such thing on this car.