First... Read your owners manual - page 226 - Turn the ingnition switch to ON (do not start) and fully depress the accelerator pedal slowly 3 times within 10 seconds and then turn the ignition switch to OFF .
Many Vehicles before OBDII need to be reset with the manufacturers computer/scanner or by shorting terminal jumper locations.
If this vehicle is newer then turn on the ignition to the position before start and press the gas pedal. If dash lights start blinking then press the brake one, two or three times then turn the key back to off and turn back to the position before start. The light should be out. This won't work if you start the vehicle. Sometimes the code is different,,exp. Turn on ignition gas,brake,brake,gas. You have to find it.
what do you reset the cehck engine light patriot manual transmission 2008? thanks for you support.
No, 1998 to 2000 should be the same, 2001 to 2002, 2003 to 2005, 2006 to 2008, should be the same.
The oil drain plug uses a 13 mm wrench.
its gonna cost u over 1,000 cause i replaced one in my dodge truck its a 01 and it cost 890
Change the pipes for Screamin' Eagle slash cuts. To stop backfiring you will need to fit venturies in the headers and then get the bike Dynoed for optimum performance.
turn the key on, engine off, press the gas pedal to the floor three times. cycle key
Turn the ignition switch to ON (do not start) and fully depress the accelerator pedal slowly 3 times within 10 seconds and then turn the ignition switch to OFF .
owners manual should have that info
Dodge does not use inertia/reset switches.
Exactly the same as the 2008.
Turn on the key....don't start the car. Push the gas pedal to the floor and release 3 times. Should be reset now.
take a hammer to the light
Turn on Ignition - depress gas pedal 3 times
Key on, engine off, press the gas pedal to the floor three times.
Key on engine off, press the gas pedal to the floor three times.
normally disconnecting one of your battery terminals and reconnecting it will reset the trouble light.
Turn the key on, with the engine off, and press the gas pedal 3 times.