Method 1 You can use the Net Send command which is a messaging service provided by Microsoft allows users to sends messages to other users, computers, or messaging names on the network. Messenger Service should be started on user's computer. The syntax of the Net Send command net send {name | * | /domain[:name] | /users} message Method 2 Use third party LAN messenger. Since the net send command line may not efficient and convenient for daily office communication. Using a specified LAN messenger to transfer message is more popular today. THe link below is a comparison between the advantages and disadvantages of net send command line and LAN messenger.
Go into command prompt and type: net send (ip address/ name of computer) (User) (message)
In command prompt write "ipconfig/all" command and then press [enter]. And see the IPv4 Address section in the commend prompt.
Go to the command prompt and run "ver" command..
PROMPT command is an internal command, which is used to change the MS-DOS prompt. Through, the system displays the prompt bu default, when you start the computer.
i think when you are on command prompt, you type ping 192.168.0.238, then you should know what to do next(i think)
shutdown -lThe computer must have hibernate set to off.Then run the following command from command prompt%windir%\System32\rundll32.exe powrprof.dll,SetSuspendStateIf Hibernate is ON the above command will place your computer in hibernate state
the command prompt is a program where you can command the computer to perform functions such as shutdown, restart, open a certain file, start a program, etc.
Open a command prompt (you will need to be running as an administrator). Type: "netsh winsock reset" (without the quotes) and press enter. Then reboot your computer. Command prompt can be found in Start -> All Programs -> Accessories -> Command Prompt. To run as an administrator simply right click the icon and select "Run as administrator" If you get a message referring to "elevation" you are NOT running as an administrator. Run the command prompt as administrator and try again.
Open a command prompt (you will need to be running as an administrator). Type: "netsh winsock reset" (without the quotes) and press enter. Then reboot your computer. Command prompt can be found in Start -> All Programs -> Accessories -> Command Prompt. To run as an administrator simply right click the icon and select "Run as administrator" If you get a message referring to "elevation" you are NOT running as an administrator. Run the command prompt as administrator and try again.
Use command prompt.
hi u can find the mac address of computer by ipconfig/all command in command prompt. Thanks
Type exit to close the Command Prompt window, or click the red X in the corner. To shut down your computer, type shutdown -s