I had this dilemma happen to myself. There are two options to assist you. I purchased a small wet/dry bucket vacuum from the Home Depot $20 has plenty of power. Take a copper fitting like a coupler or 90' elbow and tape it around the vacuum hose. Place the fitting over the copper pipe and vacuum all the excess water out. You can hear and see the water hose pumping water. Leave it on for a while until it pulls the water from the lines. Now your ready to solder. Use lead free solder it works well to with a little water. Option two , they now sell fittings which require no soldering by Shark [brand name] sold at the home depot a really good product, just a little expensive.
I don't think you can solder a pipe that contains water. You may be able to use J-B Weld.
Lead is toxic to humans (causes brain damage) thus when using a solder to join copper water pipes it is best not to use a solder containing lead as this will get into the water passing through the pipes and slowly poison the user of this water.
That cant be done because as long as there is water in them the temperature of the pipe wont go up enough to allow the solder to flow. you have to remove the water.
It is called Brazing rods or lead free solder
No, it will not affect them
Sandcloth the end being soldered. Squish the end with pliers so it is tight. Put flux on the end and solder. Easier to buy a copper cap and solder that on!
Copper is used as hot water pipes because the copper will not corrode when the hot water goes through the pipes
Lead free solder for potable water pipes
It melts solder. Solder was originally a mix of lead and tin that was used to join copper to copper (pipes and wiring) It is in the shape of a pistol, but does not shoot anything.
Copper is used as hot water pipes because the copper will not corrode when the hot water goes through the pipes
I can't think you are talking drinking water pipes because anitfreeze is poisonous. Nor should you have lead pipes or lead solder in drinking water pipes. So either sleeve pipes or heating pipes then. Antifreeze has inhibitors designed to prevent corrosion.
First off, you should shut off the water source. Then you must drain the pipe. After that you can clean up the area to be soldered, apply some flux. Now you are ready to solder. The pipe doesn't need to be bone dry, since it will dry as you solder from the heat.
50psi is a safe route. No problems there. the fittings can largely effect the pressure effect noticed once the water leaves the pipes.