0
The correct spelling is "torqued" (apply torque or force).
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Why must wheels be torqued?
Torqued wheels help keep the rotors/drums/rims straight.
What would cause a wheel stud to break on 1992 dodge spirit?
Over torqued, under torqued, age, abuse.
Can you adjust the rocker arms on a 1997 jeep Cherokee Inline 6-cylinder?
No, they are torqued to a specific amount and the lifter controls lash.No, they are torqued to a specific amount and the lifter controls lash.
Torque specs to a 1989 240sx flywheel and clutch?
Flywheel must be torqued to 105 ft/lbs. Clutch and pressure plate torqued to 22 ft/lbs.
What is the rear axle nut torque spec for a 2002 Freightliner MT45?
Assuming yours has a double jam nut, inner nut gets torqued to 350 ft/lbs, backed off, and torqued to 50 ft/lbs. The outer nut is torqued to 250 ft./lbs.
If the head bolts were torqued in the wrong pattern could they be loosened and re torqued in the correct pattern would the heads and gaskets still be all right?
Only if you have never started it.
How do you tighting the rocker arm bolts on a 1992 Firebird with a 3.1 v6 engine?
The studs themselves are torqued to about 45 foot pounds. The nuts are torqued to 20 foot pounds.
What is energy transfer used for?
To rotate the shaft and torqued the vehicle
What are 1987 350 heads torqued at?
65 ft lbs
Cadillac 500 bearing cap torque specs?
40 ARE WHAT THEY ARE TORQUED AT
Torque for head gasket for mule 3010 kawasaki?
The head gasket bolts, on a 3010 Kawasaki motorcycle, should be torqued at 35 pounds per square inch. They should be torqued in 10 pound intervals.
What are the torque wrench settings and tightening sequence for a 2000 Chevrolet Cavalier 2.2l head bolts?
New Headbolts are recommended Long bolts are torqued to 46'lbs + 90 degrees. Short bolts are torqued 43'lbs + 90 degrees. Start in the center, and work to the edges, torquing the bolts in two stages. Rockers are torqued to 22'lbs.
