0
How do you take a crankshaft pulley off of a 1996 mercury mystique?
Wiki User
∙ 7y ago
Jack the motor up and take the motor mount loose on the top right side. Carefully lower the motor down until you see the crankshaft bolt on the bottom. Then take the center bolt off the crankshaft and then the pulley will come off.
Wiki User
∙ 7y ago
Add your answer:
Earn +20 pts
Location of turn signal relay 1996 mercury mystique?
Location of turn signal relay on mercury 1996 mystique
Where is clutch fluid reservoir on 1996 mercury mystique?
On a 1996 Mercury Mystique : The brake fluid reservoir is also the clutch fluid reservoir
Is the 1996 mercury mystique 4 cylinder engine and interference engine?
No , the 2.0 liter 4 cylinder in a 1996 Mercury Mystique IS NOT an interference engine
Where is the crankshaft bolt on 1996 ford winstar 3.8?
In middle of crankshaft pulley
Where is the kick panel on a 1996 mercury mystique?
On a 1996 Mercury Mystique : There are ( 2 ) kick panels They are the interior trim panels , in front of the front doors , beside the drivers and front passengers feet
Where is the ignition control module on an 1996 mercury mystique located?
na/
How do you replace the transmission on a 1996 mercury mystique?
take it to authorized transmissions
Where is the water pump on a 1996 ford probe se?
Should be the pulley just above the crankshaft pulley
Where is the horn located on a 1996 mercury mystique?
In a 1996 Mercury mystique the horn is located in the middle of steering wheel and can sound by pressing the pad. Make sure to operate frequently to make sure it works.
Is 1996 Mercury mystic 4 cylinder interference or not?
The 2.0 liter 4 cylinder engine in a 1996 Mercury Mystique IS NOT an interference engine
How do you break loose the crankshaft pulley bolt on an 1996 Honda Accord?
You don't
How do remove a 1996 Chrysler damper pulley?
Depending on engine displacement in general remove belt-s then bolt holding pulley to the crankshaft then using a puller remove the pulley, when installing use a installer not a hammer to put the pulley on the crankshaft.
