have a jack and piece of wood handy.
1. roll the jack under the oil pan with the wood on top and raise til it touches the oil pan so when you loosen the bolts and/or nuts the engine wont drop
2. loosen the bolts for the mount
3. remove the mount
4. raise the engine up a little til its about even where it was with the mount in
5. replace the mount and tighten up
6. lower jack and check the nuts and/or bolts to ensure they are torqued to specs
Mobile synthetic!
where is the ground wire on a 2006 chevy cobalt 2.2 ecotec motor
how do you change the timing belt on a 2006 Chevy Cobalt You need to purchase a Haynes Manual at a parts or bookstore.
with the correct tools
The spark plugs for any Chevy cobalt are located under the 4 wires that go into the center top of the motor, each one is evenly spread out into a line. Unplug those wires and below them are the spark plugs
how to change rear hub on 2006 chevy cobalt 2.2l
specification on gapping spark plugs for 2006 chevy cobalt
6.5 inches
Four
Roughly 13 gallons
5
you cant