0
How do you undo the J hook on the back of the driver's seat of a Chevy Tahoe?
Wiki User
∙ 16y ago
I used a little pick to get mine undone, it was a pain but once you start it goes easy
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Does a automatic transmission from a 1998 Chevy Blazer 4.3 work in a 1999 Chevy Tahoe 5.7 liter engine?
Yes it will fit right in there and hook right up.
Where are the 02 sensors on 2002 Chevy Tahoe?
Start up by the engine were the exhaust pipes hook to the engine and work your way back to the muffler and you will find 4 of them screewed into the exhaust pipes. They are about 4 inches long with an electric wire hooked to them.
Where can you find a used factory tape deck for a 1987 Chevy S10 Tahoe?
A great place is ebay.com or your local salvage yard should be able to hook you up!
When was Brent Hook born?
Brent Hook was born on March 4, 1979, in North Lake Tahoe, California, USA.
How do you replace a turn signal on front of a 1994 Chevy lumina?
hook back the horn 1994 chevolet lumina
Where can you get mirror wiring diagram need to hook up 8 wires for 1999 Tahoe?
You can get the mirror wiring diagram needed to hook up 8 wires for 1999 Tahoe at the motor vehicle text books.
Where do you hook engine stand on back left of 1996 Chevy Blazer engine?
The engine stand bolts up to where the transmission bolts to the back of the engine.
Where do I hook up a towing Harness?
Back inside the rear drivers side wheel well, near the bumper. There is a plug from the factory.
How do you hook up the tachometer to the distributor on a Chevy 350?
on the drivers side of the distibutor cap using a blade electrical hook up you can plug into the opening or if there is a wire already there splice into it make sure all your grounds are in place or you will burn up you coil
Where does temp gauge hook to block On 1985 350 Chevy?
It goes to the temp gauge which is usually screwed in the head between the manifold on the drivers side, or into the thermost housing on the intake manifold.
How do you reset ecu on 1991 Chevy Silverado?
On that year, You can just REMOVE the battery cable for about 10 mins. Then hook it back up.
Where do you hook up a oil gauge in a 396?
A 396 Chevy engine has the oil pressure sending unit located in back of the engine, on top, close to the distributor, drivers side. The opening is a 1/8" pipe thread. You can "tee" it and have both factory and auxiliary oil gauges in operation.
