answersLogoWhite

0


Best Answer

i don't think you need to remove the enigine.....i also own a 2003 galant and i had mine done at a dealership......costed around $700 and i got it back in a couple of days.....results and prices may vary...

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How hard is it to replace a timing belt on a 2003 Mitsubishi Galant Do you need to remove engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove Mitsubishi Galant Axle?

Unbolt it.


How do you change the foglamp bulbs on a 2004 Mitsubishi Galant?

Safely jack the car up, remove lamps,replace bulbs.


How do you change a wiper motor on a 2005 Mitsubishi galant?

The wiper motor is located on right rear of engine, hood up. Remove old wiper and replace before tightening the bolts test their location to mount.


Where is the cabin air filter located on a 2001 Mitsubishi Galant 4-cylinder 24 liter engine and how do you replace it?

It is located behind the glove box. Remove the glove box completely and it is attached with two screws. Hope this helps


How do you reset the check engine light on a 1996 Mitsubishi galant?

Remove negative polar of battery and replace after a couple of minutes. FYI your car will ride rough for about a half hour while the computer re learns itself (reset)


Where is the expansion valve on your Mitsubishi Galant?

Expansion valve is located on the A/C Evaporator Core. Most of the times you have to remove the whole dash to reach it/ replace it. Good luck.


How do you replace the back plugs and wires on a 2000 Mitsubishi Galant?

if yr talking of a v 6 then remove the engine cover,turbo hoses if you have them and upper anti sway bar and then loosen the plenum , 7 bolts if memory serves,you can remove it completely but if its loosened off there is just enough room to remove the rear plugs and leads


How do you remove the spare tire from trunk on a 2000 Mitsubishi galant es?

you dont its just for show evidently


How do you remove yellow plastic fuse holder in a 2003 Mitsubishi galant?

you just pull it like a fuse


How do you change transmission fluid in a Mitsubishi Galant?

You need to remove the transmision oil pan, it is held on by aproximtly 12 screw. You have to replace the filter, use a new gasket and reinstal the oil pan.


How to replace the tensioner pulley on a 2001 galant gtz?

Remove air box, pulley is located just under attached to engine block. Should remove bolts take off belt, and replace pulley and belt.


How do you remove and install the water pump on a 1990 Mitsubishi Galant 2.0L?

use the remove timing belt instructions and it includes the water pump,"if your in there do them all !"