To dispense half a drop, you open the stopcork very carefuly and let the droplet appear and start to grow. Once the droplet reaches half it's usual size, close the stopcork. The droplet should now be hanging from the burette. Wash it down into the solution with your solvent wash bottle.
To dispense half drop, carefully open the stopcock ofthe buret then let a droet on its half size appear not allowing it to eevn get larger. Therefore close the stopcock and let the half drop slip into the flask.
5370 years. A half-life is how long a radioactive object takes for half of all its atoms to become new elements. 100 is half of 200 =)
A DNA molecule in half is called DA molecule.
The half-life is 4 days. That means half of it will be gone in 4 days, and that leaves half of the original sample. In another 4 days, half of the remaining half will have decayed. And that will leave only 1/4 th of the original sample. That means 3/4 ths of the original sample will have decayed. In 8 days, three fourths of a sample of a radioactive element with a half-life of 4 days will have decayed.
4 days
Half a gram
NaoH HAVE 6.022(10)23 IN HALF DROP.
no, it can't
You can draw less current, half the current gives half the amount of volt drop. Or use a thicker cable because doubling the cross-section area would also give half the volt drop.
Cut a fresh lemon in half and have the juice drop by drop and smell its skin to avoid vomit.
yes you can, but you half to be in highschool.
my favorite recipe for the bottlecap drink is this: fill a glass half with lime juice and half with sprite. leave room to drop a shot glass in. fill a shot glass half with raspberry sourpuss and half with rootbeer shnapps. drop the shot glass into the larger glass and drink up!
U can but in some servers ( multiplayer ) just type in console command drop hope it helps! However, in the console orange box version, you cannot drop weapons.
the goblins on the first floor drop it.
you have to rev the engine about half way then drop the clutch.
Drop forging is when half of the die is dropped from a height onto the other half of the die, which will contain the hot metal workpiece to be formed. Drop forging is used for mass production. Press forming is instead of dropping half the die onto the other half the two halves are put together and pushed together under a large pressure (up to about 10000 tons) forming the object the difference is that drop forming leaves the centre of the metal not so hard as the outside, but press forming gives more uniform hardness for larger components
Half a year
156 mph on a 16 foot drop of a half pipe