answersLogoWhite

0


Best Answer

Use a voltmeter with a high input impedance and measure at the source the voltage.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

10y ago

It is measured using a Voltmeter

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How is voltage measured?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Music & Radio

What unit is a Diode measured in?

Diodes are measured in terms of resistance. The formula is as follows Rd = Vd / Id. That is Resistance of the diode = voltage across the diode to current flowing throught the diode.


Should voltage going into home be 250V?

Its a bit on the high side, as measured between L1 and L2, but not a problem. Better for appliances than a low voltage. Lights will tend to be a just bit brighter and use a bit above rated power. Certainly a big problem if measured between either live conductors and the neutral.


What does Ohms mean for an amp?

Every amplifier has a high input impedance and a low output impedance. These electrical impedances extends the concept of resistance to AC circuits and are measured in ohms. In electronics, especially audio and sound recording, a high impedance bridging, voltage bridging, or simply bridging connection is one which maximizes transfer of a voltage signal to the load.


How do you calculate transformer voltage ratio test?

Secondary voltage / primary voltage


What is the Frequency response of common emitter amplifier?

The voltage gain is a measure of the amplified output available at the collector terminal divided by the voltage measured on the base. This if you have 10 mV applied to the base and voltage of 1 volt at the collector the voltage gain is 100ANSWERThe maximum voltage gain of a common emitter amplifier is dependant on the transistor itself. Some have only a very small voltage gain such as in Radio Frequency Power transistors. These are almost all used as common emitter circuits for bipolar transistors or common source for FETs.. On the other hand some darlington transistors can have common emitter gains of hundreds of thousands. If the stage has an unbypassed emitter resistor, the voltage gain is equal to Rload/RE, (Rload is the parallel value of the resistance from collector to the supply and the resistance of the load).If the emitter resistance is bypassed, the value of resistance to be used for RE is the internal Re which is equal to 25mV/Ie