What would you like to do?
How many ohms should an injector have for a 1976 Cadillac ElDorado?
Hi, I want to fit new injectors to my eldorado 1976 and have now found some from a company who believe it or not have 50 of these at $35.00 each..anyway in answer to your question if you have the old ones (which should be green and not blue) get your ohm meter and measure across the two terminals this way it will give you the ohms...the full presure if you are interested should be between 36 and 39 psi...ThanksChas
1 person found this useful
Was this answer useful?
Thanks for the feedback!
5 quarts and have a quart on hand for a month or two later. The filter will absorb as much as a quart from waste oil and sludge. I use Napa filters and Kendal synthetic …mix. My last 89 Seville had 475k miles before the head blew. And that was only the result of a cracked radiator. Kendal is not the most expensive but that's all I use and obviously it's been good to me.
First check the emissions label under the hood at the front of the car near the fan shroud. There is a large label telling you important information about your car. The gap fo…r a 1976 Cadillac Eldorado with a 500 ci engine is .060 in. make sure to buy good quality AC Delco plugs and torque them to 25 foot pounds.
About $6700.00 base price...options as always cost more
How many gas miles per gallon do you get in a 1994 Cadillac Eldorado Touring Coup and a 1993 Cadillac Eldorado?
you will get from 16mpg city to 26mpg highway stock my 94 eldorado gets about 14 inheavy traffic but gets about 16 normally mostly city, but when i hit the highway it goes up …to 28
It weighs 5,080 pounds.
Answer One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. … 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
With the flywheel timing mark aligned at zero, #1 cylinder (front left facing engine) should be at top dead center and distributor rotor should be pointing at #1 post (1st pos…t clockwise past the battery connector on the dist cap). If the distributor has been removed and reinstalled, the rotor may point at the opposite post (180deg out). If so, the distributor will have to be lifted enough to allow the rotor to be turned back to the #1 post. Be careful, if you try firing the engine with the timing significantly off, she will kick back into the starter, possibly damaging the starter gear or worse....! Once started, set the timing to 12deg btdc....good luck! Mike
ETC stand for Eldorado touring coupe I should know i have one.
Late model? I replaced the Bose rear speakers in my 95 Eldorado - not fun. You have to take the back seat out (both parts - bolts through to the trunk and down by the se…atbelts), remove the package tray cover (fuzzy part between the rear seat and rear window), and yes, it's glued down... Use a long flat screwdriver so something similar to pry it apart without destroying it. You should have unplugged the speakers while you were in the trunk. Now you should be able to see that the speakers actually snap into place, and you'll have to carefully pry them out of two fasteners that hold them down.
Passenger side behind the glove box.
Get a manual from DISCOUNTAUTOREPAIRMANUALS.COM and get an answer to both questions. They are about $9
There are eight injectors, and possibly a ninth one, if it has a cold start injection system. there should be 1 per cylinder