This depends on what material the plumber uses, what fittings the plumber uses, how much piping will be used and how long the plumber will take.
Install a checkvalve
Install an automatic air vent on the line
Of course as you as you protect it JUST like radient heating is considered water lines in a concrete slab
The only reason for this would be due to a blockage. Either snake your sewer line or call a plumber to carry out an investigation to find out where the blockage is.
is is most certainly a blockage in the sewer line. Call a plumber to come and check it out and clean your sewer line for you.
Not a plumber however I do know it varies buy region. You need to know the depth of the freeze line in your area. That will determine the depth to install your hydrant.
Get a plumber to trace your cold water lines to find out where the heat is getting into the line.
New Water heater. Faucet and sink drain line repair parts. The sinks, commodes, house and yard water supply lines. Sewer lines
Install a checkvalve
I am not a plumber, but am in the process of installing a water line myself...and all of the research I have done says the water line should be hooked up to the cold water.
Usually at the beginning and at each fixture.
You would contact a plumber. Depending where the leak is, the city may need to be contacted for repair.
Have a plumber snake out your drains.ANS 2 - Install a flapper valve section on the sink drain pipe so water can go down but not up - cheap and very easy to do.
Remove the top water line from the radiator to the water pump. The thermostat is found there.
Remove the top water line from the radiator to the water pump. The thermostat is found there.
Install on cold water line.
Install line from the outlet of the tank and run line to the last fixture and bring it back to the bottom of tank with a pump