0
How much it would be to replace seat belt clips on 2001honda civic LX?
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
You have a 1997 Honda Civic EX how long would it take to replace the starter?
Where is the starter on a 1997 Honda Civic?
How do you remove and replace the headlight lenses on a 94 Civic CX?
I found four little metal clips oround the housing but after that it was still on there very well. besides heating it up to melt the glue i would say replace the thing, they're pretty cheap at a wrecker... hope i helped.
How much it costs to replace a clutch on a 97 Civic EX?
I am having the clutch in my 95 civic dx replaced today. It is going to cost me about $980. Not sure if yours would be more or less.
How much would it cost to replace a new bulb on a 2005 Honda civic?
about $4000-$12,000 depending on how bright you want it
How do you repair your radiator in a 92 Honda civic?
Pull it out, take it to a radiator shop and have them do it. Or what I would do , is just replace it with a new aftermakret one.
How much should it cost to replace a blown head gasket for a 1995 Honda civic?
I would say around 300 dollars..
Where would transmission fluid leak on 2006 Honda civic?
Accel oil seal. 4 oil seal must be replace
What other parts do you need to replace in 1998 Honda Civic when you replace your head Gasket?
You will need the intake and exhaust manifold gaskets. I would also install new head bolts.
Is it difficult to replace the brakes on a Honda Civic?
The entire brake can be difficult but the brake pads are easy. I would trust a mechanic to do the entire brake at your local garage.
Replace Cluch on 95 civic?
This is a process that should be done by an experienced person. Would be a lot better to be shown how its done by someone who knows what their doing, not told how.
What would be heavier a pound of bricks or a pound of paper clips?
paper clips
Do you have to replace a drive shaft to replace the you joint?
No. There are 2 U joints, 1 front and 1rear. If they are the factory U joints they are sealed with a plastic meaning no clips on driveshaft side. If you are not of high mechanical ability I would take it and have it done.
