What would you like to do?
How much oil does a Honda trx450r hold and what is the best weight to use?
8 people found this useful
Was this answer useful?
Thanks for the feedback!
Answer . 4 quarts. Closer to about 4.4 quarts if you let enough oil drain. Refer to the manual located (hopefully) in your glovebox.
If you have an owner manual it should tell you. When changing the oil filter most vehicle of this type take at least 3.5 quarts. Some bigger gasoline engines might take up to …5 quarts. I would add 3 quarts than check the dip stick and add accordingly, before I started the engine. The service advisor at the service department of a Honda dealership should know exactly. My husband says 3.8 qts.
Check your owner's manual under, "capacities" or "fluids". It's highly likely the capacity is about 5 quarts but could be less. It's NEVER ok to over-fill. If you ever take th…e vehicle in for oil service, always check the oil level 20 minutes after the engine has been shut off or immediately after they lower the vehicle from the lift. You can tell the service advisor, "I'd like to double-check the oil level BEFORE the start the engine". You pull the dipstick, check, wipe and re-insert. Check 3 times. If it's a LITTLE UNDER, that's ok, but if it's over the max line, tell them you'd like some oil removed. Good Luck!
About half a quart.
The Hond CBR 125 holds 1.00 Litres of Engine Oil. you should buy the haynes manual it is cheap same price as road tax and tells you everything
The 2006 Rubicon holds 4.9 qts when you change it. It is for both the engine and transmission.
I just changed the oil in mine: with the filter replaced it took 3.5 quarts.
from some random manual...\n. \nChange oil at initial 300 km (185 mil and at \nevery 1000 km (620 mil thereafter. \n1. Oil Change \na. Remove the oil cop and drain the engine… com- \npletely of oil by unscrewing the plug at the bottom \nof the engine. (Fig. 6-15) \n(Note) \nThe oil should be drained while the engine is still \nwarm. This will save time and assure .proper \ndraining. \nb. The proper oil level is indicated by the oil level \nmarkers on the gouge when checked without \nscrewing the cop down. (Fig. 6-16) \nOil capacity \nCBjCL175: 1.5 f, (3.2 U.S. pt. 2'.7.lmp pI! \nCBjCL 125: 1.2 f, (2.5 U.S. pt, 2.1 Imp. ptl \nOil Brand and Grode \nThe grade of oil for the season is shown on the \nupper crankcase. Use the oil corresponding to \nMS. DG in the A. P. I. service classification. \n(Fig. 6-17) \nUnder OÂ°C (32Â°F) SAE lOW \n0Â°_15Â°C 132Â°-60Â°Fl SAE 20W \nOver 15Â°C (60Â°Fl SAE 30
The manual for my 2007 VLX600 says it holds 2.38 US quarts/(2.25 liters). I am assuming that means with a filter change but it does not come right out and say that it does.
.8 of a liter .8 of a US quart.
i use a 20w-50 jaso rated oil. the 50wt. because its an air cooled motor
In Honda Accord
Almost all Honda's V6 or 4 cylinder hold 4.5 quarts. Change the oil/filter, add 4 quarts, start the engine, shut down, wait 30 minutes and check the oil level. Add as necessar…y to reach the full mark.
If you look on the case next to where you put tranny fluid in, it should tell you. There is no engine oil in a 2-stroke(as it is mixed in with the gas). I am assuming you are …asking about the trans fluid.
one quart of four stroke motorcycle oil. I use 10w 40. do not use car or truck oil!