a steering wheel puller is quite inexpensive and is the best way to remove the steering wheel I wouldn't recommend trying any other way.
As an alternative method to use without causing much damage, or to steal one? Do you need to bypass some ignition points, or do you need to get around the steering lock also?
you dont they are self adjusting with the tentioner pully...
crank pulley.
With a vibration damper pulley puller.
It's a left hand thread. Crank to the right.
check the idler pully is not siezed start the truck and have someone give it a little gas or reach under the trottle body and pull on the linkage to the trottle body to give it fuel watch the idler pully should move a bit to tighten or loosen the belt and all ...if ideler pully seized the idel of the truck will sputter ,,,,, could also be a bad spark plug with i had on my 2004 causing the truck to miss fire on one cylinder ,, which was more noticeable at low idle
the idler pully is the top center that that spins freely and is connected to the block.
IT IS ON THE PASNGER SIDE . UNDER THE BOTTOM OF TRUCK ON THE SIDE OF THE TIMING COVER. YOU WILL SEE IT.THE CRANK PULLY , BALANCER, WILL BE IN LINE WITH IT. LOOK FOR A PIGTAIL GOING INTO THE SIDE OF THE TIMING COVER. IT IS ON THE PASNGER SIDE . UNDER THE BOTTOM OF TRUCK ON THE SIDE OF THE TIMING COVER. YOU WILL SEE IT.THE CRANK PULLY , BALANCER, WILL BE IN LINE WITH IT. LOOK FOR A PIGTAIL GOING INTO THE SIDE OF THE TIMING COVER. IT IS ON THE PASNGER SIDE . UNDER THE BOTTOM OF TRUCK ON THE SIDE OF THE TIMING COVER. YOU WILL SEE IT.THE CRANK PULLY , BALANCER, WILL BE IN LINE WITH IT. LOOK FOR A PIGTAIL GOING INTO THE SIDE OF THE TIMING COVER.
How do you remove power steering pulley on a 1990 ck truck
If your pully is damaged. Take it off and find the part number. Call Cummins and order it. If you don't have a pully to go by. Call Dodge with your truck serial number or Cummins with your engine serial number and they can trace it.
no not without adapters
Increase mass For a truck increase the load on the truck