Prep work. If you can go to a self wash car wash and clean the area really good. Remove the under carriage brush guard. Remove the battery.Place the car on a jack and remove the right wheel to get access into the wheel cavity. Now disconnect the connections on the motor. one is a 10mm nut and one a push in connector with a tab to hold in place. Once off there are 2 bolts holding starter on. I suggest doing the one underneath first since the other can be done easily. Once lower is all the way out then loosen the top one and remove it. You can just slide the starter out the wheel cavity. There might be a small metal piece that needs to be removed. reverse order to install. Just don't tighten down the bolts until both are in and snug.
its broke
you can go in behind the light through the bed liner, or remove the taillight cover
The harmonic balancer on a 1990 Toyota 4 Runner is turned clockwise to loosen it. This is backwards from most bolts to prevent it from being loosened by the rotation of the engine.
Maybe
It holds 5 quarts
Remove - battery cable Raise and support vehicle Disconnect the wiring at the top of the starter Remove starter mounting bolts Remove starter
Take it to the junk yard starter is almost impossible to remove . Good Luck
Not lubricated
how do i replace a power steering pump in a 1990 toyota camry?
== ==
i also need step by step instructions on how to take off old starter and replace new one if any one knows this would be very helpful to me. thanks
First, the battery needs to be disconnected...Safety first. Second, remove the electrical connector from the side of the starter. Third, remove the nut holding the ground wire (below connector). Fourth, remove the two bolts that hold the starter. Pull the starter away from the engine block. You may need to twist and turn it a little to get it around some of the wires and hoses. Install in reverse order.