take grab handle cover off.remove screws.remove screws for door handle trim plate.remove screws on front of panel.remove screws on rear of panel(pop off screw covers and you will see screws).Pull out bottom of door panel.Gentle pry off tweeter up by mirror and disconn wire.Panel can come off enough so you can reach in and disconn window sw and door lite.remove panel.As best as you can peel off vapor sheet(its messy).Now you will see 2 blk plastic covers on sheet metal.pry them off.Disconn motor elec conn.Remove 3 nuts holding on motor.push motor to opening where you removed the larger plastic cover.You have enough room to turn motor and unscrew gear from old motor.Carefully pry gear away from motor.Put old mtr aside and attach gear to new motor.Push motor back up and reattch with the 3 nuts.Reconn elec conn.REvers procedure to reinstall door panel.Make sure all electrical conn are hooked back up.I did this on my 2003 tib and I believe 04 is same.
you need to pull the plastic off on the inside of the car to access it.
its in the panel on the left of the back seat behind the drivers side.
Flip open the cover and remove the two bolts securing the wiper arm. They are 12mm and 7/8 inch. Remove the inside hatch panel by removing four screws and working the panel loose. Unplug the wiring harness from the motor and remove it with a Philips head screwdriver. Replace the interior panel.
hammer PS use the right to
rear door panel ,how to open.
Push the door panel in around the window handle and use a screwdriver or a piece of wire with a hook to pull the clip off....it's in behind the handle.
A door panel on a 2005 Hyundai Accent is mounted with screws and clips. Loosen all the mounting screws. Pull the panel outward and pop out the clips. Remove the door panel.
Answerto remove the door handle you need to remove the door panel, which has 5 screws around it. One is under the handle you have to pry the cover off with a flat head (THERE IS A SLOT FOR THE FLAT HEAD) after that make sure your window is all the way UP NOT DOWN. there you should be able to see the 2 10mm bolts holding the handle bracket. You should be able to see the two metal rods push them until you can slip the plastic clips off and there you have a door handle from a 00 to 06 hyundai tiburon sitting in your hand
You must remove door panel and replace window regulator.
if you are referring to the stock amp, then you will find it behind the rear seat panel on the drivers side right next to the speaker.
On manual window regulator equipped models remove the window crank handle.A shop towel worked up between the handle and door panel will usually dislodge the clip but it can also be removed with a hooked tool # Remove the outside mirror # Detach the door handle trim piece and disconnect the linkage rod.Remove the door pull mounting screw.Unplug the electrical connector from the power window switch # Remove the retaining screws and detach the panel by carefully prying it away from the door
A door panel on a Hyundai is secured with several screws. Loosen and remove and the screws then proceed to gently pull the panel outward. There are several clips for extra support. Pull the panel outward and the clips will come off as well.