Needed: Phillips screw driver, Ford Din removal tool.
Step 1 of 5
Disconnect the negative battery cable (or grounding cable) from the battery of the Ford Edge. The grounding cable is the black cable that connects the Ford's battery to the chassis or frame of the vehicle. Use a Phillips-head screwdriver to loosen the bolt on the cable's clamp. Remove the clamp from the battery's negative lead post.
Step 2 of 5
Insert the Ford DIN removal tools into the face of the stereo. There are two holes vertically aligned on either side of the stereo's face.
Step 3 of 5
Pull outward on the DIN tools (away from each other) and toward you, pulling the stereo from the dash.
Step 4 of 5
Disconnect the wire groups from the rear of the stereo. The groups are for the antenna, speakers, amplifier and power supply. There also may be connections for an equalizer, a satellite radio receiver or an iPod or MP3 player.
Step 5 of 5
Reconnect the grounding cable to the Ford Edge battery. Place the cable's clamp around the negative lead. Use a Phillips-head screwdriver to tighten the clamp's bolt. The clamp needs to be tightened so that it cannot be moved around the battery's lead post by hand.
hi there, take the car to your ford dealer he can remove the radio to get the serial number off it then he will chech with ford motor company for the code.....
It pull's off and snaps back on.
remove the 2 plastic side panels. then you will see 4 small holes, insert a coathanger or other small object in to each hole and push away from the radio. then pull out the radio
You will have to remove the stereo unless you have the box, which is not a possibility, since the radio unit comes pre-fit from Ford. 1. Remove stereo from car. 2. On the right hand side of the unit, locate the serial number label.
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
The radio is removed from a 2008 Ford Edge by removing the control knobs and loosening the retaining nuts. The surrounding trim is then pulled, wiring harness detached, and the radio removed from the console.
how do you remove the radio from an 06 f250
how do u remove the radio from 1996 f 350 ford truck
How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck
2012 ford e-250 radio removal
with a crowbar
Go to : http://www.cthreepo.com/blog/2009/09/swapping-the-radio-in-a-ford-ranger.shtml
Unscrew it.
Go to walmart and purchase the Ford radio or the Scosche DIN Radio Removal Tool.Cost is about $7. with this you can have the radio out in seconds, literally.
hi there, take the car to your ford dealer he can remove the radio to get the serial number off it then he will chech with ford motor company for the code.....
Thomas Hodge
To remove the dash to get to the radio from a 2005 Kia Optima, begin by prying around the edge of the trim around the gear shifter. Then, remove the screws from the bottom of the dash and pry the trim away from the radio area. This will expose the radio bezel.