Hi. I've done this but it is not easy. What I did was to remove the inner cover of the brackets holding the canvas roof in place. Then undid all the bolts and loosened the roof catches. Then got a box cutter knife and carefully cut the stitching between the front and rear sections of the canvas roof and pulled the back section off witht he plastic panel. I took it to an upholsterer who stitched in Marine grade clear plastic and put it all back together. I am a qualified auto engineer, but took my time. Overall around 6 hours.
To replace the Ford Explorer rear window hinge, you have to buy a similar window hinge. Use a screwdriver to open the hinge and replace the hinge but fitting it in the window.
There is a control module from Chevy for $65.00 that controls the rear window defrogger and antenna signal. Its located in left rear window pillar behind the plastic trim. its very simple to replace.
In the top of the trunk near where the brake light is located, there is a small plastic window, remove it and you access the light bulb.
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
Remove the plastic head liner panel (roof)Take out the plastic side storage bins in the backseat (sides) Then the rear window plastic side plates can be removed. Factory 4x6's.
It is easy to replace the window regulator or window clips on the rear window of a 2000 Grand Am. The clips simply snap right onto the rails inside that door that connect to the window.
I replaced my whole top with a one piece top with plastic rear window. It only cost $246 on eBay and it came with all the instructions I needed. It took me a weekend to do and it was easier than I thought. The only disadvantage of the one piece top, which I didn't find out until it was installed, is that it doesn't fit as well into the "boot" when open and the boot cover won't quite fit.
Does the Sash Channel need to be removed before installing the window
all the slinding rear windows that i put in you had to replace the whole rear glass
Yes
The plastic on the rear window motor of a 2001 S-10 Blazer is black. It surrounds the majority of the motor and is easily distinguishable from the metal.
To replace a rear window regulator on 2005 CTS Cadillac remove the side protection panel of the car door then adjust the regulator.