0
If a force of 15N is applied to a disk with a radius of 0.5m. What is the torque?
Wiki User
∙ 11y ago
T = R x F
T = 0.5m x 15N
T = 7.5 N*m
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
A 2.8kg 40cm diameter disk is spinning at 260 rpm How much friction force must the brake apply to the rim to bring the disk to halt in 2.0s The answer should be in Newtons?
Torque is equal to friction force (F) * radius (r). Torque is also equal to moment of inertia (I) * Angular acceleration (a). Angular acceleration is equal to rotational velocity * 2Pi/time, which is 2 seconds. So, F = IRa/r, or 45.63 Newtons
Why can hydraulic car breaks be described as a force multiplier?
When you step on the brake pedal, a force is applied directly to a piston of area 'a'. The hydraulic fluid thus pressurized is directed to other pistons of area 'A' >'a' at each wheel which push the brake pads against the rotating disk attached to the wheel. Since A>a, the applied force is multiplied by the ratio A/a.
What are the examples of applied physics?
Applied physics can be seen in the movement of research tools into them home as consumer goods. The lasers in optical disk players are an example. My radio controlled wrist watch is another example. What about the computer on which I am typing this or the spectacles through which I am reading my monitor? All applied physics
What is the moment of inertia of a circular disk rotating about an axis if the mass is m and radius is r?
The answer will depend on whether the axis isthrough the centre of the disk and perpendicular to its plane,a diameter of the disk, orsome other axis.Unless that information is provided, the answer is meaningless.
How do explosive formed projectiles work?
Known as the Miznay-Schardin effect, a section of metal is shaped into a projectile by the force of an explosion. Also known as a platter charge, a metal disk with explosives on one side is turned from a disk into a bullet when the explosives are detonated, and driven forward at high speed at the same time.
A 2.8kg 40cm diameter disk is spinning at 260 rpm How much friction force must the brake apply to the rim to bring the disk to halt in 2.0s The answer should be in Newtons?
Torque is equal to friction force (F) * radius (r). Torque is also equal to moment of inertia (I) * Angular acceleration (a). Angular acceleration is equal to rotational velocity * 2Pi/time, which is 2 seconds. So, F = IRa/r, or 45.63 Newtons
What will happen if you apply a force on top of a disk kept on a frictionless surface?
The disc will slow down as a result of the friction applied by the force.
The radius of a circular disk is 22 centimeters what is the diameter of the disk?
Diameter = 2*Radius So, in this case, diameter = 44 cm
Why can hydraulic car breaks be described as a force multiplier?
When you step on the brake pedal, a force is applied directly to a piston of area 'a'. The hydraulic fluid thus pressurized is directed to other pistons of area 'A' >'a' at each wheel which push the brake pads against the rotating disk attached to the wheel. Since A>a, the applied force is multiplied by the ratio A/a.
What is the surface area of circular disk?
If r is the radius of the disc, then pi*r2 square units.
What is the interior of a circle?
The set points whose distance from the center of the circle that is less than the radius. A disk.
What are the torque settings for a Renault scenic rear brake disk nut?
220Nm for Scenic, Grand scenic 280Nm
Why would a 2002 Pontiac Grand Am vibrate vigorously in drive when the brake is applied?
warped break disk
What is the Area of a disk with a radius of 112.7 km?
If the disk is circular, the area of one circular face is 112.72 X pi = 3.990 X 104 square kilometers, to the justified number of significant digits.
What are the torque specs on a 93 F-150 for the clutch?
15 to 20 pouunds of torqe if you have a 10" or 12" disk. this is what it says in my manual 15 to 20 pouunds of torqe if you have a 10" or 12" disk. this is what it says in my manual
What dynamic disk status will occur whenever a dynamic disk becomes inaccessible?
Dynamic disk get invalid or unreadable, as we all know, dynamic disk can not be recognized by Windows Home Edition. For example, dynamic disk applied in Windows XP Pro Edition, then, upgrade the OS to Windows 7 home, dynamic disk becomes invalid; accidentally power off when write data to dynamic disk; hardware environment changed.
Imagine a sector within a circular disk of radius 2 feet if the measure of the central angle of the sector is two thirds pi then what is the area of the sector in square feet?
The area of the sector is a fraction of the area of the whole disk. So, we need to find the area of the whole disk and then multiply by the ratio of the sector size to the disk. The ratio is 2/3 pi out of a disk that is 2 pi all around (like any circle). Twos cancel, "pi"s cancel, so the sector is 1/3 of the disk. The disk's area is pi times (the radius squared). Pi times four. Well, to avoid using irrational numbers, the disk's area is 4 pi. The sector is 1/3 of 4 pi square feet, which is 4/3 pi square feet.
