If after you replace aerator what to do next if leak continues?
Where is the leak at? The aerator is in the end of the spout, it may have a plastic or rubber seal between it and the spout. A leak any other place is probably an O ring.
1 person found this useful
Why would a faucet continue to hiss and make gurgling sounds and eventually leak after replacing both hot and cold cartridges?
Answer . either air is getting into your lines or something in your water is getting in the o rings in your cartridges. air can get into your lines if you have even a small… leak you don't know about. it could also be that either copper shavings or sediment from your water lines gets jammed into the o rings. The other problem could be to high of pressure coming into the building. you can install a pressure reducing valve to correct the problem.\n. \n . The "hissing and gurgling" would concern me. Check your water heater right away. If it is electric, is an element always energized, and if it is gas is the burner running a lot or constantly? Is the Pressure relief valve plugged or inoperative for any reason? Does the water from the heater seem to be really hot? Over 140 degrees F? You might be making steam, and this is a very dangerous situation, SHUT OFF the energy or fuel source immediately and call a qualified plumber.
Could use some help with 1991 Chevy Caprice leak at the heater core pipe and snap hose assembly you replaced the snap hose assembly but the leak still continues at the connection point of the pipe?
Chevy Caprice Classic Answer . \nBe sure that the quick connect orientation tabs are properly aligned before connecting the heater pipes to the heater core tubes. If these… aren't properly aligned then coolant leakage and damage to parts may occur. The quick connect fittings must be pushed on, then pulled back to verify proper engagement, don't rely on an audible click or visual inspection to check for proper connection. You may need to remove the leaking hose at the quick connect and try it again to make sure it's connected properly.. Answer . Thanks. I'll give that a try. I did take it apart and reseat the hose thinking it might be out of alignment. Someone mentioned to me that they had a similar leak on a GM transmission snap-on line they replaced. They suggested putting a little vaseline on the inside of the hose O-rings, which worked to stop the leak they had.
What should be done next to a 1996 Cadillac Seville on which the temperature gauge continuously rises but the radiator has been replaced?
\n. \n Answer \n. \nIf you haven't replaced the thermostat, now would be a good time. If that's not it, check the impellers on the water pump.\n. \n Answer \n. \…n. \nThe temperature gage is supposed to rise to around mid level. If you mean it is getting hot, then Replace the thermostat. Also check the operation of the cooling fan and the water pump. Another possibility is that the cooling system needs to be bled. There may be air trapped in the system.\n. \n. \n. \nanother thing we often see with this era northstar is blown head gaskets.
97 Tacoma 128k miles Thermostat replaced Radiator cap not leaking Still running hot Water pump next?
You may have a faulty coolant temperature sending unit. This is just a sensor that tells the computer, and your dash guage, how hot the engine is. It's possible your engine is… running in exactly the temperature range that it should, but the sensor is telling your dash guage that it's too hot, and causing you to worry. You probably have more than one, so consult a manual or your mechanic before trying to replace it/them. If this doesn't solve the problem, another thing to do is flush your coolant system. You may actually want to do this first, since it will be cheaper than replacing sensors, and it really should be done anyways just as a precaution around that mileage. Take care of your Toyota, and believe me, it will serve you reliably for a very, very long time.
An aerator is a way of introducing air into some process or other. Probably the most common is in your home faucet. Instead of a stream of "solid" water, your faucet probably …has a little collar with a fine mesh grid that breaks up that solid stream of water and introduces air into it. You still get the same water pressure, but the actual volume is reduced, so you save water that way. But there are many forms of aeration. If you have a giant vat of taffy or bread dough, there are probably giant paddles to stir it around to fold air into the mixture. You can find aerators in fish tanks to. My fish tank has an aerator pump, that can oxygenate 342 gallons of water an hour and filter it. When the aeration valve is off it can pump and filter 400 gallons of water, due to the air introduced into the stream of water is off and not displacing the other 58 gallons of water. An Aerator is also a tool used to aerate your lawn. This type of machine will make holes in your lawn and leave cores. It is called and aerator because it makes it easier for air and water to access the soil roots. You also have aerators that can be used for making wine
Aeration is the abillity to entrap air. In relation to food e.g. whisking egg whites for a soufflÃ¨, the addition of sugar helps aeration which occurs when the egg whites ar…e whisked. The mechanical action of the electric beaters produces heat by friction (the rubbing together) which causes denaturation or unfolding of the polypeptide chain within eggs. This change is irreversible. Friction and heat produced by the electric whisk slightly coagulates (sets) the protein around the air bubbles. A soufflÃ¨ will rise to a height because of air trapped in whisked egg whites. A small amount of salt or sugar helps to make the whites more stable and so will help trap the air for longer. The egg whites should be whisked until they form stiff but billowing peaks but not dry peaks. If overbeaten they will be very dry and not fold into the sauce. The egg yolk is mixed with a wooden spoon. The gradual addition of sugar alongside mechanical action assists denaturation of the egg yolk. A 'bain Marie' consists of placing a container (for example, a pan, bowl, ramekins or soufflÃ¨ dish) with food in a large, shallow pan of warm water on the hob. The water surrounds and protects delicate foods from direct heat, alowing them to be prepare "low and slow" because foods such as chocolate can burn easily from direct heat. The sauce in a "bain Marie' is then allowed to cool. The egg yolk is then mixed into the cool chocolate. If hot, the egg proteins would curdle or begin to cook in the sauce. Once the egg whites are whisked, they are folded carefully into the base sauce to maintain air in the mixture. The soufflÃ¨ is placed on the lowest shelf of the oven allowing it to rise upwards within the heat of the oven. As cool air enters the oven (alongside cool air in the soufflÃ¨) it's warmed, becomes less dense and rises thus pushing up the soufflÃ¨. When the filling the souffÃ¨ dish, it's important to leave 2cm from the top of the dish otherwise the base wll swell; the soufflÃ¨ will run over the sides and not have time to set. Onced placed in the oven the proteins livetin, vitellin, ovalbumin and globulin will coagulate. Coagulation is the setting of the egg proteins. This happens at 65oC for egg whites and between 65-70oC for egg yolk.Coagulation of the egg proteins and baking at the correct tempreature for the correct time allows the soufflÃ¨ to set as it rises.
My 2000 Chevy Malibu leaks antifreeze and overheats. I have already replaced the head gaskets and now the problem continues. What else could be wrong?
I just had my intake manifold replaced on my 2000 impala that could be your problem it is kinda costly though it cost me about $1000 here in Pa.. OTHER CAUSES OF OVERHEATING… . You don't say where the coolant leaks from. If the leakage is from the engine, determine where it is coming from and start looking from there. If by leakage, you mean overflow from radiator or coolant reservoir, then here are some causes of overheating that you might consider: thermostat stuck in closed position; faulty water pump; broken fan blades; loose belt; clogged radiator; radiator cap not holding pressure; blown head gasket; low or no coolant; leaking hoses.
To aerate is to add air to a liquid, like water. Liquids can hold aset amount of gasses from air. Aeration is achieved by . agitating the water (waves or by hand) . passin…g air through the water (bubbles from a hose) . passing water over air (waterfall) To make it more specific, it's to put air or a gas into something.
Loose transmission lines, blown torque convertor seal ,dried out pan gasket. where the leak is would help description of faul . i,e the front of the of tranny at the engine tr…anny mating surface or under the unioit itself or out of the cooler lines.
Is it over full?
Yes you Should
Is it easy to replace the bi-pass Coolant hose to the oil cooler for a Honda 1993 also what would happen if you continue driving when the coolant is leaking?
No its not that easy of a job and if you continue to run it this way, then you could damage the engine.................
Of course you can,it happens to me all the time. This is what I mean: if you have your period on February 27th, and your period usually lasts 5-7 days, it would continue on th…e the early week of March! GOOD LUCK!!!!!!!!
My 1995 ford Windstar continues to overheat even after i replaced the thermostat what should be my next place to look for a reason why?
the heater pipe is not working the dealer only sale this part two hose run from this.