0
If you replaced the flasher and it still doesn't work what else could be the problem?
Wiki User
∙ 16y ago
Multifunction Switch, the turn signals, wiper blades, and headlights. This multifunction stalk can fail. Oddly enough so can your key. When you start your car the key should be rotated backwards after ignition. If the spring fails or the key binds then this does not happen, typically you will not have a blower motor for heat and a/c at the same time. Simply turn the key backwards to a normal "on" position and retest. first of all make sure that the right flasher was changed. there usually is one for the turn and one for the hazzard. they are identical.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Your Car blinker does not go on anymore but all the light bulbs work what could be the problem?
Most likely turn signal flasher needs to be replaced
If you have a 93 Buick Regal and have replaced the turn signal flasher and the bulbs aren't blown then what else could be the problem of why they don't work?
The flasher is just for controlling the intermittent electrical current. There is also a fuse in the fuse block under the dash. It could be in the switch on the column.
Where is the flasher relay located on a 1998 Mitsubishi Galant?
the flasher unit is up behind the driver side .Its up and behind the fuse box . you will need to laying on you side to see it. just pull it out and replace it. If that doesnt fix it it could be the plastic on the switch . i just replaced it.
After replacing fuses on 1995 Nissan Altima Turn signals still don't work hazards work fine what can be the problem?
Could be turn signal flasher Could be problem with switch in steering column Could be turn signal flasher Could be problem with switch in steering column
Driver side turn signal lights up but dont flash and the dash signal stays on all the time but the other side works fine could this be a flasher or wiring?
your flasher is bad i had the same problem and replaced the flasher .it is located behind your e brake lever in dash there are 2 one emergency and one for turning the top one is turning
How do you fix the signal lights staying on on a Chevy veture van?
The most likely cause of this problem is that the turn signal flasher is starting to "stick" and needs to be replaced. Depending on the mode year of the van, the flasher could be in different locations, but the most common spot is under the dash, near the steering column.
What causes signal lights on my 2004 Chevy Classic not to work?
Could be flasher Common problem on this vehicle Flasher is part of the hazard warning module
If the turn signals are not working on a 1994 Dodge Spirit but you replaced the flasher and fuses what else could be wrong?
I just had the same problem and found that my rear turn light bulb went out and the turn signals no longer worked. Check any of the turning bulbs. You may have replaced the hazerd light flasher. There are two flashers, the turn signal one is near the hazerd one under the dash.
Why do I hear my blinkers going off when I don't have them on and then when I depress my brake the sound stops but when I let off the brake the blinkers sound again?
The problem could be that your flasher switch is going out. I had the same problem on my 99 blazer. It sounded like a bee buzzing in my dashboard. Had the switch replaced and problem was gone. Hope this helps.
Why would right turn signal and hazard lights work but not the left turn signal-left lights work when hazard lights are on Installed new turn signal switch still no change.?
Depending on what type of vehicle it is, it could be the combination flasher relay. 2000 Dodge Caravan, same problem. Replaced DRL/Flasher Relay, problem fixed. Was an expensive dealer only relay...
Why might the turn signals not work on an '86 F150 when all bulbs fuses flasher have been replaced and in-stalk contacts are clean?
be sure you are getting current on both sides of your turn signal switch when you turn on the blinker. This could be the problem.
If the turn signal flasher on my instrument panel doesn't flash but the turn signal does what could be the problem?
Burnt out bulb.
