I am rewiring a 71 super beetle. So far I have connected one of those half as wide connectors on a red wire to the K lug on that little light. Black power wire coming from a green wire on the emergency flasher pin #15 should connecto to the little #15 lug.
A Blue wire should connecto to the little #61 lug. This wire comes from main harness and GEN warning light on speedo. One or all of these wires with tiny connectors should ne hanging around in there somewhere. Good luck.
The switch should be the same as your headlight switch. If not then you will either need to install your own switch for the running lights or buy a new OEM switch module.
Hey LaMarcus==There is a short somewhere. You need to get a wiring diagram as I am quite sure the radis is supposed to be on a separate fuse not wired with the lights. GoodluckJoe
Not enough info... If the lights are dim, there is an illumination wire that dims the lights when the headlights come on at night... could be a bad switch. If your lights are totally gone... so is your radio. It is a sealed unit not meant to be serviced. Even if you could find someone to repair it, by the time you were done, it would be cheaper to buy an aftermarket or an original factory Delco from eBay.
You need to replace the dimmer switch in your gauge cluster. This was caused by a bad ground happens all the time.
The switch or button for the fog lights could be shorting out (water got in?). or there is an exposed wire you aren't aware of...a positive wire touching ground, or corrosion somewhere in the circuit.
yes you can install factory fog lights on a non fog light car,however, there may be some fabricating of brackets to mount the fog lights to.also you must either install your own switch or wire them directly into your parking lights.
it would cost somewhere around 10 dollars. give or take 5
If the aftermarket lights are not a factory option then the lights will need to be drilled into the bumper. Afterwards the lights will also need to be properly spliced into the existed wire harness.
If I were doing it, I'd wire it in direct to the battery, and install a fuse in the wire somewhere (somewhere accessible) between the battery and the switch for the lights.
Factory fog lights went through the ECM... if you want to get that involved, the answer is going to be longer than anyone is going to be willing to type out. The simple way, if you have an empty slot in your fuse panel, install a fuse and run it off of that. Place a switch in the circuit on the live wire, and ground the lights to the chassis or frame.
These bicycle lights are really easy to install on to your bike See link below
The easiest pond lights to install are the ones with lighting connecters on them. The connectors for the pond lights will make installing the pond lights quick and easy.
where do you find the replacement bulb for a 2001 Chevy Malibu ls for fog light replace ment on the car
form_title= Trailer Lights form_header= Install trailer lights with help from pros. Do you have a commercial trailer?*= () Yes () No What color lights do you want to install?*= _ [50] How many lights do you want to install?*= {1, 2, 3, 4, 5, More than 5}
If you have a 2.5 s or sl or a 3.5 se it is prewired. You just replace the headlight switch and install the lights. cost is 220 to 275 from dealer. I just got quote today. Or aftermarket system would need to be wired in. There is a seller on eBay named zipmotor. He has the complete oem-like kit with wiring harness and switch for the dash just like the factory lights. They're selling for 120 to 130, much better deal than the factory.
It shouldn't be that hard to install fog light. If you cant find the wire hardness in the same location. You may have to run new wires to a separate switch.
In a light switch factory......