0
12 V DC
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How much voltage AT89c51 can bear as input?
AT89C51 can have a maximum of 6.6v as input voltage
How much lm317t ic can bear voltages?
The LM317 voltage regulator can be set to any output voltage from 1.2 V to 37 V. You must keep the input voltage between the maximum input voltage and the drop-out voltage for proper operation. The maximum input voltage the LM317 is guaranteed to bear is 40 V. The LM317 is guaranteed to operate when the input voltage is at least 3 volts above the set output voltage.
What is the maximum voltage across unbiased positive silicon diodes limiter during positive alternation of the input voltage?
0.7 V
What causes maximum secondary coil voltage?
I would hazard a guess and say that it is a bad coil.
How do you calculate full load for 500amp welding machine?
You need the input voltage and maximum input current specs found on the name plate.
How a transistor work as an amplifier and as a switch?
"Transistor" name itself revels it transfers resistance from its input to its output (Transfer of resistance). Input resistance varies when input voltage varies, similarly output resistance varies and this leads to voltage variation at the output. Thus input to output voltage variation is called amplification. this is how transistor can be used as an amplifier. If input voltage is minimum output voltage becomes maximum i.e. its output resistance becomes maximum in common emitter configuration. Thus if no voltage is applied at the input its collector resistance becomes infinite or as if open circuit. Similarly if input current is increased output current increases and out put can behave as short circuit. This is how output current can be switched off or on using no input current or with minute input current. Unlike a digital device, the transistor is an analogue device which can be switch on/off to maximum or any gradient in between. Providing a small AC voltage to the base creates an amplified analogue of this signal across the emitter and collector.
Why clipping happen for op-amp?
Clipping occurs in the voltage waveform when the input voltage, multiplied by the voltage gain of the op-amp circuit, exceeds the op-amp supply voltage as limited by the output network. The supply voltage and output network, limits the maximum voltage that can be achieved at the output. The op-amp behaves normally within its range of maximum voltage output, and then it is clipped when it reaches the maximum voltage of the circuit.
What might cause maximum secondary coil voltage?
What might cause low maximum secondary coil voltage?Low primary input voltageLow primary resistanceWide spark plug gapsOpen spark plug wire
What might cause low maximum secondary coil voltage?
What might cause low maximum secondary coil voltage?Low primary input voltageLow primary resistanceWide spark plug gapsOpen spark plug wire
Use of transistor 7812?
7812 is not a transistor. It is a three lead voltage regulator integrated circuit. Its maximum input voltage should be near 35 volts. The minimum input voltage should be near 14 volts. The output will be 12 volts.
What does oscilloscope an measure?
An oscilloscope takes an electrical input signal and converts it into a visible trace on a screen - i.e. it converts electricity into light. An oscilloscope helps us to measure the voltage(maximum)....We can also find frequency from it by using a Equation.. We can use the maximum voltage in this equation i=v(maximum)sinѠt to find the current.
What is PIV in electronics?
The Peak inverse voltage (PIV) equals the peak value of the input voltage, and the diode must be capable of withstanding this amount of repetition reverse voltage. For the diode in figure, the maximum value of reverse voltage, designated as PIV, occurs at peak of each positive alternation of the input voltage when the diode is forward biased.Peak Inverse Voltage at Positive Half CycleThe Peak Inverse Voltage (PIV) occurs at the peak of each half-cycle of the input voltage when the diode is forward biased . In this circuit, the PIV occurs at the peak of each positive half cycle.
