European circuits need a transformer.
North American circuits have 120/240 Volt supply. Using a neutral and one of the hot lines would work.
To understand, think of two twelve volt batteries connected together in series.
The voltage on the outside two terminals is 24 volts. The voltage from any outside terminal to the center is 12 Volts.
With two wires from each of the outside terminals and one from the center, giving you the option of 24 Volt or 12 volt with three wires.
A volt can not be connected to a circuit.
Every device in your house that plugs into a standard outlet and also the various lights in use in a typical residence.
The current will remain in a 220 volt circuit as long as the circuit load remains in the circuit and the circuit remains closed.
There is a 3.75 Volt drop across each bulb.
First, someone would have changed the plug before that would be possible. 240 Volt receptacles do not accept 120 Volt plugs. Second, IF someone changed the plug on the compressor, then plugged it in using both legs of the 240 Volt circuit, the compressor motor would self destruct instantly; internal wiring would burn and you would smell the burning insulation.
A map of a circuit is not a volt. A map of a circuit is referred to as a schematics chart. The schematics chart details the path of the circuit, from beginning to end.
It depends on the use it is being put to. It is sufficient for a 24 volt circuit. Too much for a 12 volt circuit and too little for a 240 volt circuit.
If you are talking about a 6 volt coil, yes, so long as the contacts are rated for the 230 volt circuit. If you are talking about 6 volt contacts, no, absolutely not.
Yes, in the form of GFCI circuit breakers, not as a receptacle.
No, not a good idea. You have to use a 347 volt ballast.
If your cart has 4, 12 volt batteries in series to make up the 48 volts, just connect the 12 volt lights across one of the batteries.
headlight have a circuit breaker insted of fuses for safety purposes take a volt meter and see if u have power to the lights if not trace wires back until u do