0
Is the 1996 4 cylinder Geo Metro hydraulic lifter built into the rocker arm?
Wiki User
∙ 12y ago
No, they are not. They are removable, but i do not suggest reusing them. They are hydrolic lifters and have a spring in between them. The following web address you will find them on the page I have posted for you. They are 50% of what napa is asking for them. A really good place to buy engine parts. Your looking at $7 a piece. I would suggest replacing them.
http://www.store.partsdinosaur.com/page48.HTML
Good luck
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the oxygen sensor on a 1991 Geo Metro 3 cylinder?
in the exhaust pipe right under the manifold it is easy to get to right in front under the hood
How do you change just the lock cylinder on a 96 Geo Metro?
Locate the core key of your car. The core key is used to withdraw the cylinder or core from the lock housing. Insert the key into the core and turn is slowly about 10 degrees and remove the key to pull the housing. Install the new cylinder.
How many Aston Martin Austin Metro cars were produced?
Zero. Do you meant MG Metro??
Is replacing a 1996 Geo Metro water pump the same procedure as replacing same on a 1994 metro?
Yes
Can the 1995 geo metro 1.3 L engine bolt onto a 1992 geo metro 1.0 L engines transmission with little or no modifications?
Yes, but your final gear ratios will be different. This URL discusses changing the transmission from a 1.3 into a 1.0 for a Suzuki Swift (the Metro is a re-badged Swift). The process should be the same in a Metro. www.teamswift.net/viewtopic.php?t=26466
How do you repair broken 89 Geo Metro lifter?
no fix for lifter.... must be replaced... remove valve cover, remove rocker arm assembly replace bad lifters.... put it all back together
Geo Metro. How do you remove and install hyd lifters 1.3L 95-97?
you must remove the entire rocker arm assembly... inside each rocker is a little button lifter. that's the ones to be replaced... To set the entire rocker assembly back in place, you will need 4-5 hands to squeeze the springs and position the rockers over the valves
Does a 1992 Geo Metro have an interference engine?
yes, if it's a 3 cylinder Mr Geo Metro yes, if it's a 3 cylinder Mr Geo Metro
93 Geo Metro has interference between valves and pistons?
Yes, if it's a 3 cylinder sounds like timing belt has slipped so crank and rocker arm are out of sink(timing). get a book from auto parts store , will tell you how to check
Can you put a 1999 Geo Metro alternator in a 1996 Geo Metro?
If the engines are the same size then yes (ie) 3 cylinder 1.0L to 3 cylinder 1.0L.
Can you take a 4-cylinder from a 1995 metro and put it in a 1991 Metro convertible that had a 3 cyl in it?
yes
Where is the first cylinder in a 3 cylinder Geo Metro 1998?
Number one cylinder is the one closest to the passenger side fender.
Will a transmission from a 1991 Geo Metro fit into a 1998 Geo Metro?
No, a 91 metro transmission will not fit in a 98. A 91 will fit any metro between 1988 - 1996 though. After 1996 a lot of Metro's became 4 Cylinder which made them different from the previous generation metros. It may fit if the engine sizes are correct (1.0 litre 3 cylinder to the same but do not mix and match).
Valve adjustment 95 Geo Metro 4 cylinder?
non adjustable
How much oil to fill Geo Metro 3 cylinder?
3.75 qts
Where to buy 3 cylinder timing belt cover for a Geo Metro?
chevy
Where is the fuel filter on a 200 Geo metro 3 cylinder car?
Are you referring to a 200 model Metro? If so, there is no fuel filter to replace. 1998-2000 Metros have a fuel strainer in the tank. I have a 1999 Metro 3-cylinder and learned this over the summer when contacting the Chevrolet dealer. Are you referring to a 200 model Metro? If so, there is no fuel filter to replace. 1998-2000 Metros have a fuel strainer in the tank. I have a 1999 Metro 3-cylinder and learned this over the summer when contacting the Chevrolet dealer.
