it would be on the floor on the driver's side in front of the seat. if you reach down with your left hand, it should be right next to the front of the seat ================ I own a '91 GL and there is no lever or switch to open the hatchback, I have always had to do it manually. Other models or years may have incorporated one however, and it probably wouldn't be too hard to find. Chances are if you can't find one, it doesn't have one. -Shaun
The sensor for the engine coolant on a 1991 Ford Probe LX is inside of the coolant tank. There is a lever, and when the fluid gets below this lever, it signals to be checked. It should be refilled.
on a 94 Ford Probe GT the fuel cutoff switch is in the rear, inside the car, behind the left rear wheel wheel and below the level of the floor. remove rear carpet and look behind the left rear wheel well inside the car (under the hatch). I would have to asssume that it is located in the same place.
Next to the "Pop the hood" lever inside the car.
If you are talking about the inertia switch, it is in the hatch on the driver's side under the floor mat behind the wheel well.
are you sure its fuel cut out? my probe would not start traced problem to electronics inside distributor had failed [common fault on probe]
If it's the same as the 1996 Ford Probe , it's in the hatch area - lift the carpet in the drivers rear area of the cargo area , you will see a rubber cap / plug , push the raised area of the plug in order to reset the fuel shut off switch
There is a fuel cut-off switch located in the trunk (hatch) under the mat, usually on the drivers side. If it's tripped, check the fuse as well. -CE
Air Probe.
A probe is a tool that is inserted into something to view or get information abour what is going on inside that object. A satellite that goes into deep space is an example of a probe.
not a whole hell of a lot. for the moon roof just point your vent up there and let it go! for the hatch you can put a smaller fan in the corner pointed at it then just put it on a switch ACE wipe all condensation out and then replace seals in hatch and roof
Yes. Be sure to change the neutral switch from your probe as the mazda's will plug in but is wired different.
o my