check to be sure you are getting power to the swith itself. If you are, check to be sure power is getting to the motor when the switch is pushed. If you are getting power to the motor and it is not working. 1st check for a good ground, next repalce the motor. also, make sure that the connectors attaching to the switch and the motor itself are good and tight. Make sure that none of the terminals inside the connector have backed out of the plastic housing. If you have a good power and ground source to the switch, try "hotwiring" the window motor itself. Make a jumper wire and use it to apply voltage to the correct terminal at the motor. If it still doesn't work, use that same jumper wire and jump from the motor to a good known ground. If all this fails, replace the window motor.
i need a diagram to install a window motor on a 1980 gmc truck
Remove the door panel and unclipped the three plastic retaining tabs that hold the window motor in place disconnect wire connector and it's out
how do you bypass electric window switch on 88 toyota pickup
replace 1987 dodge pickup/power window motor
there should be a latch or your drivers key will open it
take off door panel, disconnect wires, remove mounting bolts and and lift mechanism.
undo the bolts that atatch the roll bars to the window on drivers and passenger side, the undo the bolts on lower window that hold the window to the tub on both passenger and drivers side. the window should now fold outwords onto the hood, once it is on the hood the wiper motor will on the drivers side window frame. remember to disconect the battery before any of the steps
I have a drivers side (front) speaker that went out. I think the problem is a speaker connection. How do I remove the window crank (not power windows) and then the whole inside panel?
YES there the same.
I assume you have a VIN number on the registration or in view from the window of the drivers side dash. You need that number and your check book- go to the dealer.
under the seat in the fuse box it should be the fuse directly above the window relay
Remove the 1997 Chevrolet Suburban drivers side door panel. The window mechanism will be visible. Place the new window into the window track. Secure the window to the track.