Autozone.com gives you access to free online repair manuals. You just enter your vehicle information and log on and you can use them anytime.
You remove your Water pump after that you'll figer it out
Go get a chilton manuel from Kragens. You do have to remove the timing belt.
remove belt via tensioner, four bolts on pulley, five on pump, clean and reverse
how to remove power steering pump
Driving it into water
To remove the water pump on a 3.4 or 3.1 V-6 simply remove the 4 bolts from the water pump pulley, remove the drive belt, them use a large screwdriver and pry just a little and rotate and pry until the pulley pops off. May use penetrating oil, the center of the pulley sometimes gets stuck on the water pump.
driver side of engine, has a double pulley on it with 4 10MM bolts. Remove the pulleys off of it, remove timing cover, remove belts, remove bolts in pump and replace. Dont forget to replace the O ring on the water pump pipe that does into it, this is overlooked and very important.
Pump it out with an inexpensive hand pump.
how to remove powersteering pump
On my 96 ranger its on the passenger side basically on the firewall
take drive belt off first. then turn water pump pulley. notice the hole on front of pulley. use this to access all pump bolts behind it.
Yes the pulley has to be removed, To time this disconnect the spot plug(disables the computer) and set timing to factory spec's