Saturns are just a little different than other automobiles. You don't remove the inside door panel to get to the mechanism, instead, you remove the outer door panel.
Open the door. There are several screws around the perimeter of the door, some near the bottom. They must all be removed.
From the outside, lift the handle and notice that there are two pins holding the door handle in place. They need to be pressed out, then you can pull the handle off the pegs.
Once the screws and the handle are off, the outer door skin lifts off.
how to remove the door panel on a 1992 mercury cougar
You can remove the rear door panel from your 1992 Mercedes 300 SE by removing the clips on the perimeter of the door skin. Once the clips are removed the door panel should come off.
Since this question is in the Saturn area, it must be assumed that you are asking about removal of a Saturn door panel. The inner door panel of a Saturn is not removable, it is integral to the door frame. However, you can remove the outer door panel. First, remove the outer door handle; lift the handle enough to reveal the pins that hold the handle to the door latch mechanism, then press out the two pins and set the handle aside. Next, open the door and remove the screws around the perimeter of the outer door panel. After the screws are removed, the outer door panel should lift off easily.
No. To remove the widow its easiest to remove the outside panel
Remove the 1992 Dodge Dakota inside door panel. The door handle mechanism will be visible. Remove the door handle linkage. Remove the door handle retaining bolts.
I don't know - but the question about the 1993 door handle is the same...
Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker
Replacing a skin is not a job for an amateur.
Should be able to access after removing inner door panel
You will need to remove the inside door panel. Remove the door handle retaining screws. Remove the linkage from the back of the door handle.
The inside door panel cannot be removed; instead, to get to the inner workings of the door remove the OUTER panel. Lift the outer door handle to expose the pins that hold the outer handle to the door mechanism. Then press out the pins and remove the handle. Then remove the screws around the perimeter of the door that hold the outer panel. The panel should lift off, exposing all of the inner workings, then you can verify that the inner panel does NOT come off.
remove the door handle and window crank (you can use a coat hanger to remove the clip) remove the door lock knob. Then reach down at the bottom and pull out the panel. Install in the same order.