Base
A bipolar junction transistor with 2 or more emitters. The most common use of these was in the input section of transistor transistor logic (TTL) gates. They offered significantly higher speed and used less area on the IC chip than the diodes used in the input section of the diode transistor logic (DTL) gates that came earlier. This made TTL ICs both faster and cheaper than the DTL ICs which soon became obsolete.
Transistor=Transfer+Resistor. When Transistor operates in active region its input resistance is high and output resistance is low. So,We can consider transistor as a device which transfers its resistance from high to low. And by this property transistor amplifies input signal.
the sum of all vertical forces is called shear force
A small signal NPN transistor used for general purpose audio amplifiers and switching.
A silicon transistor is a transistor made of silicon.
The base.
the center section of PT called transition metal or d-block element..
transistor. This word is a blended form of transfer of resistor. The legs of transistor (collector, emitter,base) transfer the resistance. So it is called as transistor
Its not!
A bipolar junction transistor with 2 or more emitters. The most common use of these was in the input section of transistor transistor logic (TTL) gates. They offered significantly higher speed and used less area on the IC chip than the diodes used in the input section of the diode transistor logic (DTL) gates that came earlier. This made TTL ICs both faster and cheaper than the DTL ICs which soon became obsolete.
The saying "at what current is transistor biased" means to ask the current through the transistor when there is no signal present. Typically, a transistor is biased at the center of its linear region, so as to minimize distortion. This, of course, depends on whether or not the transistor is AC or DC coupled, and where the clipping points might be.
Transistor is called Bi-Polar device because the current can be flow due to electron and holes, hence it is called bipolar.
<center> Link <center>
Transistor=Transfer+Resistor. When Transistor operates in active region its input resistance is high and output resistance is low. So,We can consider transistor as a device which transfers its resistance from high to low. And by this property transistor amplifies input signal.
no.
When the out from a transistor is the exact replic of the input signal then it is called unmodulated signal i e. there will not be any change in frequency voltage power etc
the sum of all vertical forces is called shear force