To reset a breaker move the handle completely to the off position. If it had tripped you will feel a little resistance as it goes to the off position. If this doesn't restore the power the breaker is either bad and in need of replacement, or there is a persistent fault in the circuit causing the breaker to immediately re-trip. Breakers are safety devices.
If the breaker is damaged it will not reset to the on position. It will stay in the tripped position.
If you can reset it, then it is not a fuse it is a breaker. You use then so you do not have to replace a fuse, you can just reset the breaker.
The operating handle will be found in mid throw. On smaller type electrical breakers there is a small trip indicator window and a red flag will be visible when the breaker has tripped. On larger physical size breakers you will definitely see that the handle is not in the off or on position. To reset any size breaker move the handle to the full off position. You might hear a click but you will definitely feel the internal mechanism re-latch to the off position. This has reset the breaker, move the handle to the on position and normal electrical power will have been restored. If you get an instantaneous trip after a reset do not try and reset the breaker again. Find the cause of the short circuit and get it repaired. Constant and repetitive resetting will destroy the breaker and increase the temperature of the short circuit. If the short circuit is in a highly combustive area this is not good. Find the problem and get it repaired.
There may be a breaker or more likely a pair of fuses. Yes, they may need to be reset or replaced (if fuses).
The purpose of a circuit breaker is to protect electrical circuits from short circuiting.
An electrical safety device that can be reset and used again fits the description of an electrical circuit breaker.
An electrical safety device that can be reset and used again fits the description of an electrical circuit breaker.
You reset a circuit breaker by pushing the reset button.
You can pull the front panel off the Hot Water tank and there is a red reset button on the electrical that controls the power to the elements. Or, try resetting the breaker on the electrical panel serving the tank.
If the breaker is damaged it will not reset to the on position. It will stay in the tripped position.
A manual circuit breaker must be reset by hand, as opposed to an automatic circuit breaker, that may be able to reset itself once it cools down.
If you can reset it, then it is not a fuse it is a breaker. You use then so you do not have to replace a fuse, you can just reset the breaker.
A self resetting breaker will reset itself once the short is removed, repaired, If it will not reset the breaker has failed or the short is still present.
An electrical breaker is a safety device used to open a circuit that has an electrical fault on it.
The operating handle will be found in mid throw. On smaller type electrical breakers there is a small trip indicator window and a red flag will be visible when the breaker has tripped. On larger physical size breakers you will definitely see that the handle is not in the off or on position. To reset any size breaker move the handle to the full off position. You might hear a click but you will definitely feel the internal mechanism re-latch to the off position. This has reset the breaker, move the handle to the on position and normal electrical power will have been restored. If you get an instantaneous trip after a reset do not try and reset the breaker again. Find the cause of the short circuit and get it repaired. Constant and repetitive resetting will destroy the breaker and increase the temperature of the short circuit. If the short circuit is in a highly combustive area this is not good. Find the problem and get it repaired.
You should replace the surge strip if the circuit breaker fails to reset.
there is no breaker, u have to replace the fuse