What would you like to do?

Timing order 350v8 85' Chevy Caprice on distributor?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

The firing order on most GM V8 engines is 1-8-6-3-5-4-7-2.
On the distributor cap, if the distributor shaft and timing chain have been properly installed, the number one terminal is closest to the carburetor or throttle body.
CORRECTION!!! 18436572 is the correct firing order
26 people found this useful
Thanks for the feedback!

How do you remove the distributor cap and rotor on a 1994 Chevy Caprice?

The Distributor Cap on the 93 and 94 Caprices are fastened to the base with two screws. The screw in the front of the Distributor Cap is relativley easy to access. However, th

Which is the number 1 peg on the distributor cap and what is the firing order from there on a 1986 Chevy Caprice Classic sedan v-8?

1 should be the first terminal to the right of the bat connector housing, the distributor turns clockwise, and the firing order is; 1-8-4-3-6-5-7-2 IF U had the Distribu

How do you change the distributor on a 1994 Chevy Caprice Classic?

      All 1994-96 vehicles, use a new distributor ignition system which was originally developed for use on Corvette. The new system known as the Opti-S

How do you change a distributor cap for a 1991 Chevy Caprice?

The cap only has 2 phillip head screws in it . one one the front and one on the back side . just make sure u remember where all the spark plug wires were when you take them of

Where is the distributor cap located on a 94 Chevy Caprice Classic?

All the way back in the middle of the engine If you have the LT1 motor and you don't find the distributor in the back. Look behind the water pump, just below it. LT1's are lo

How long does it take to replace the distributor on a 96 Chevy Caprice?

Not long. 1 bolt on retainer & it just pulls out of block. Note firing order before you pull any wires. Find #1, go around cap terminals tracing them to each cylinder. Should