To get a diagram on how to replace a serpentine belt on a 1988 Ford F150 pickup?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

You should be able to find the diagram in the Haynes "How-to" Manual for your truck, some of these books are available at gas stations, we always pick one up at the local NAPA or AutoValue Auto Parts store. Great books, always convenient when you have an older vehicle!!!
http://www.autopartswarehouse.com/shop_parts/repair_manual/ford/f150_pickup.html
6 people found this useful

Where is the serpentine belt diagram on a 2002 Ford Taurus?

Answer . There should be one under the hood either on the hood itself or on the nose when you lift the hood, if you don't find it there check in the owners manual sometimes they will have simple diagrams like that, if your's doesn't you can go to auto zone or advance and if there is someone compe (MORE)

Where do you get a diagram on the Internet for the serpentine belt on a 1990 Ford Probe?

Answer . \nMost sites will make you pay for info like this. There should be a digram somewhere under the hood, usually in view of where you would be changing it.\nIf not, (like me) make friends with the hottie behind the counter of your friendly neighborhood parts store and ask to look at the "H (MORE)

What is the procedure in replacing the serpentine belt for a 1988 cutlass ciera?

Answer . If it is a 3.8 there will be a tension pulley at the center of the engine. if you are standing on the right side of the car (P/S) That pulley will have a 1/2 ratchet slot in its center. Taking your 1/2 ratchet handle place it in the slot (to make this a bit easier I use some type of exte (MORE)

Where can you find a serpentine belt diagram for a Ford Contour?

Answer . I would start by taking a trip to your local auto parts store or large bookstore and purchase a Haynes or Chiltons repair manual for you Ford Contour. They are on average $25 for the manual, but they will almost always answer any questions pertaining to your car. Belt diagrams should be (MORE)

Were can I get diagram to install the serpentine belt for a 1999 Ford Escort?

Answer . \nIf you have a 1.9 liter engine:\n. \nIf you look down at the belt area, you will see a pully toward the front of the car that looks like it's attached to an arm. That is the tensioner pully. The tensioner is spring loaded. If you look at the arm of the tensioner there should be a squ (MORE)

Where can you get a diagram to replace a serpentine belt on a 1993 Chrysler LeBaron?

There should be a sticker with the diagram on the right strut tower. If it is no longer there the way to find the information (and a lot more related to your vehicle) would be to buy a Haynes manual for your model from an auto parts store or go to your local library and look in a Chilton manual. Mos (MORE)

How do you replace the serpentine belt on a Ford Focus?

Most cars and trucks today have what is called a serpentine belt which runs most accessories.They are very dependable and usually easy to replace. To decide if your belt needs replacing, simply look at the grooved side of the belt to see if it is cracking badly. A couple of cracks every 3 inches is (MORE)

How do you replace the serpentine belt on a 1983 Ford F-100 pickup?

Answer . \nThere is probably a belt tensioner that the belt runs around. To release the tension, the pulley must be pushed or pulled the opposite direction that the belt is pushing on it. Or, there should be an adjustment for the power steering pump that can be loosened. You might start there.

How do you replace the serpentine belt on a Ford Ranger?

Most cars and trucks today have what is called a serpentine belt which runs most accessories.They are very dependable and usually easy to replace. To decide if your belt needs replacing, simply look at the grooved side of the belt to see if it is cracking badly. A couple of cracks every 3 inches is (MORE)

How to remove and replace a serpentine belt on a 1988 jeep Cherokee?

the power steering pump has a 3 bolts that lock it down lossen them up and behind the pump you will see a tension bolt its lond and threaded with a nut on the end loosen that up the power steering pump will slide down a bite just enough to take the old belt off but remember of how it goes on so you (MORE)

How do you remove and replace a serpentine belt on a 1988 Jeep Comanche?

Answer . Loosen all visable bolts on power-steering pump (4.0 Liter only). Take a 12mm socket with approx. 4-6" ext. (3/8 drive will do nicely....) and reach UNDER the right-hand side of the pump, and you should find a tensioning bolt. Relax tension until belt comes off. You may need a small pry (MORE)

How do you replace serpentine belt on a Ford Falcon?

You need to have a 3/4 ratchet and a piece of pipe to slide on ratchet handle. There's a square socket in a tensioner arm, insert the ratchet into a socket, slide the pipe on ratchet hanle and rotate clockwise. This will relieve the tension off the belt so you can take it off (easier to slide it off (MORE)

Serpentine belt diagram 2002 ford escort zx2?

Friend of mine needed hers put back on... again. Found the diagram at www.autozone.com You gotta sign up with them, but it seems relatively harmless. Anyways, found the diagram under Repair Info / Engine Mechanical / Accessory Drive Belts. I would post the diagram here but I don't see any wa (MORE)

Where is a serpentine belt routing diagram for a 1994 ford F150?

I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine There should be a sticker near radiator shroud that has belt routing. If not stick the belt down past the right side of fan/water pump .put belt on crank pul (MORE)

How do you change a serpentine belt on a 97 F150 Ford?

Serpentine Belt Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate the belt tensioner, and then put the belt back on as shown in the diagram. If it is not you can run down to your nearest auto (MORE)

Diagram for a serpentine belt 1998 ford f-150?

Serpentine Belt Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate the belt tensioner, and then put the belt back on as shown in the diagram. If it is not you can run down to your nearest aut (MORE)

Diagram for a 2004 Ford Escape serpentine belt?

The diagram is similar to a Ford Focus. This applies to a 2.0L Escape 2004. http://www.fixya.com/uploads/Images/A4E447B.jpg Ford stuck a diagram on the front fender of the Escape 2004 but it was incorrect.

Where can you find a diagram to change a serpentine belt on a 1996 ford f150?

Serpentine Belt Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate the belt tensioner, and then put the belt back on as shown in the diagram. If it is not you can run down to your nearest aut (MORE)

How do you replace the serpentine belt on a 1988 Chevy Celebrity 2.5?

On a V6 engine the serpentine belt is on the right (passenger) side and is tensioned by a spring-loaded swing arm and pulley. This arm can be pulled up to allow the belt to be replaced. In theory, it can be done be one person, but it's best if that person has three arms. . To replace the belt, put (MORE)

How do you change serpentine belt on 2003 ford F150 4.6?

use a 1/2 inch ratchet on the pivot point on the tensioner pulley, and turn to take tension off the belt...then slip the belt off all the other pulleys. install the new one, by squeezing it into a small loop that can be inserted into the space between the tensioner, and the idler pulley, loop it on (MORE)

Diagrams to replace a Ford Windstar serpentine belt?

Diagram of the belt routing ? Diagram of the pullies/tensioner configuration? See "Related Questions" below for . For written instructions for replacing a belt, . For links to online sources of routing diagrams . Online sources of illustrations/diagrams/photos

How do you replace a serpentine belt on a 1988 celebrity?

To replace the serpentine belt on a 1988 Celebrity: 1. There should be a routing diagram in the engine compartment. If there is no routing diagram take careful note of how the belt to be replaced is routed. 2. Use a suitable tool to release the belt tensioner, then slide the belt off of the idle (MORE)