8086 main application is to evaluate the arithmetic operations in any systems that uses 8086
that depends on the microcontroller. check the datasheet.
It depends. From the CPU's point of view, 16 data lines are necessary in a 16-bit microprocessor. Some implementations, however, such as the 8088, use an 8-bit bus, instead of like the 8086, which uses a 16-bit bus. The Bus Interface Unit (BIU) handles the conversion, packing, and unpacking transparently to the Execution Unit (EU or CPU).
: hi.. : i have a little idea about this question.. : because of low power consumption and accurate measurements we can use static relays based on microprocessor in power system networks. also filtering of noise is possible with static relays(based on microprocessor). : also for continious monitoring and security we can use these microprocessors.
Digital electronics involves logic 0 and logic 1. It involves the devices and circuits such as gates, flip-flops, latches etc. The basic idea of Digital electronics is mandatory for microprocessor & microcontroller and also for computer architecture. So, any application which involves microprocessor or a computer have digital electronics in it. It can be security applications, error correcting & error detecting , power saving circuits etc.
There are many different instructions and registers in the 8086/8088. The question is too broad. Please ask a more specific question. Alternatively, you can consult a good book, such as "The 8086/8088 Primer", Second Edition, Stephan P. Morse, Hayden Book Company, or any of a wide variety of other books.
The 8086 microprocessor has 40 pins.
It is mightily referring to Microprocessor 8086 . I think you saw "8086 microprocessor". The 8086 is nothing it indicates the number of microprocessor same as Digital or analog ic's . 8086 microprocessor has 20 Address buses and 8 data buses which has 1 Mb inbuilt memory for performing several type of airthmatical and logical operation.
queue of 8086 microprocessor is 6 bits
The 8086 Microprocessor operate to require frequency that is provided by clock generator to 8086 Microprocessor and also Synchronization various component of 8086.
it is a 16 bit microprocessor & it has 40 pin .
Pins 1 and 20 in the 8086 microprocessor are (both) power and signal ground (GND).
Two ground pins are used in the 8086 microprocessor to increase the bus pull-down current capacity.
Which microprocessor accepts the program written for 8086 without any changes?
Its 16bit microprocessor,and-> the 8086 has a 16bit databus 20bit address bus-> the intel 8086,is designed to operate in two modes namely(1) minimum mode(2) maximum mode
ya possible
The BIOS function in the 8086 microprocessor is called an interrupt function. It is an interrupt function because it is not called by a function call instruction.
Its MRDC (memory read control) it is a maximum mode pin in 8086 microprocessor