Transformers don't work on DC. If the voltage supplied isn't the one you want, it can be difficult. If you want a negative earth, and someone else in the house wants a positive earth, you have problems. Transmission of DC over large distances has problems (to get low currents to ensure low transmission power losses you would have to convert to AC, then transform to high voltage then finally convert back). In fact in all cases the easiest solution is to convert your DC to AC, make your conversion, and then reconvert to DC. Very messy.
what is meant by dc components???
DC is more powerful, the actual ratio is 1.732AC=DC
DC currents only go for one mile so you have to have a power station every mile.
Advantages,disadvantages,working principle,theory,dc biasing conditions,input and output wave forms go to mycircuits9.blogspot.com/2012/05/rc-coupled-amplifier_07.html
It is non isolated SMPSDirect effect of input output voltageNot suitable for high power conversionlow amount of dc step up
well the transformer is always full wave half wave refers to the one diode on the output for dc other than spending less for diodes there are no disadvantages to full wave diodes are a LOT cheaper than capacitors if you need clean dc if youre buying wall warts get the full wave if it costs the same
Disadvantages of DC: * High power transformation of voltage is less convenient than AC. AC uses a transformer. * DC does not have the natural break in transmission that AC has (zero twice per cycle) and does not switch off as easily * DC does not provide time to synchronous clocks * DC dynamos or generators are less efficient at converting input power to output electricity than AC alternators. That is why altenators with rectifiers are now used in vehicles instead of DC dynamos.
In armature speed control, speed can be varied only below the rated speed. Also in it voltage drops will be high.
The brush-less motor controller has a smaller output current than one DC motor. The brushless also has less of a output voltage. The maximum output voltage is 50V, where a regular DC motor would have a maximum of atleast 60V.
yes, i think dc transmission is best, coz in dc losses is low, no iductance between conduct, less corona loss.AnswerNeither is 'better'; they each have advantages and disadvantages. For example, although there might be less losses with d.c. transmission, the equipment required to raise and reduce the voltage at each end of the line is more costly than for an a.c. transmission system.
converting dc current to dc in different voltage rating
12v dc to 3v dc