Check all of you bulbs on the car, more than likely one is burned out...
I have 1998 it is your door jam switchs
The most common causes would be low coolant and inoperable radiator fan.
The airbag light stays on when the computer has detected a malfunction and set a code. The codes need checked with a scan tool to know possible causes.
When a Chrysler Sebring is stalling it is possible that poor gasoline has been used. It is also possible that the car needs the spark plugs replaced.
My 2002 Chrysler Sebring has 154K miles on it and the front end rattles when it goes over bumps. When I jack the car up and push in and out and side to side on the wheels their is no movement. Nothing seems to be lose when I pull on the front end. I had the same problem on my 2002 Sebring Lxi Sedan. Problem was worn swaybar linkage and bushings. I had the linkage and bushing replaced and the rattling disappeared.
The causes for cylinder 2 to misfire in a 2001 Chrysler Sebring with a 3.0 engine is a faulty spark plug or a damaged spark plug wire. In-depth troubleshooting can be completed by a local mechanic or dealership.
The trunk is open or the ajar switch has malfunctioned.
I have a 2002 Chrysler Sebring convertible. If you turn off the ignition and remove the key while the headlights are on, then turn off the headlights, the headlights will stay on for 30 seconds and turn off. You can avoid this by turning the lights off before you turn off the car or by switching them on and off again.
Heater core is shot, its monted on the firewall behind center console/instrument cluster. When turning on heater fan, will dischrge coolant out of the vent. Replace heater core to resolve the leak
There are a few things that can cause a low idle in a 2002 Chrysler Sebring. The fuel pump may not be working right, the fuel injectors could be old, or the car could be low on oil.
If the timing belt in the 1998 Chrysler Sebring causes damage to the valves and the head when it breaks, they will have to be replaced. It is recommended that the water pump also be replaced when replacing the timing belt.
Two likely causes are a failed water pump or a failed head gasket.