A purely resistive load is one in which there is no capacitive or inductive reactance. Whe driven by an AC voltage source, such a load will have no shift in phase angle between voltage and current.
When there are no inductive or capacitive forces at work in a resistor.
With a pure resistive load the Power Factor should be 1.
Incandescent lamps are nearly pure resistive loads with a power factor of 1
It does not contain unidirectional outputAnswerA purely resistive circuit is an 'ideal' circuit that contains resistance, but not inductance or capacitance.
That depends on the circuit. For a pure resistive circuit (no inductance and capacitance), the frequency will have no effect on the current.
resistive index (RI) resistive index (RI)
With a pure resistive load the Power Factor should be 1.
Incandescent lamps are nearly pure resistive loads with a power factor of 1
ratio between true power and apparent power is called the power factor for a circuit Power factor =true power/apparent power also we conclude PF=power dissipated / actual power in pure resistive circuit if total resistance is made zero power factor will be zero
Watts = Volts x Amps x Power Factor. To answer your question requires that the Power Factor be know. The Power Factor ranges from zero to one and is one for a pure resistive load. If your device is resistive the answer is 1500 watts.
It does not contain unidirectional outputAnswerA purely resistive circuit is an 'ideal' circuit that contains resistance, but not inductance or capacitance.
That depends on the circuit. For a pure resistive circuit (no inductance and capacitance), the frequency will have no effect on the current.
Typically you are referring to a pure resistive load and not an inductive load. To measure a resistive load you need an Ohm meter. You can buy cheap ones for $10 to $20 on-line or at a store like Radio Shack. Usually they are combined with a volt meter.
It is resistive much load
resistive loadAnswerIf the current is driving a motor, then the load is resistive-inductive.
Power factor does not apply to a resistive circuit. Just the current will follow the voltage (in phase)
Amps is a measure of current flowing in a circuit. Volt-Amps or (VA) is a measure of power and is equivalent to wattage for a pure resistive load.
A pure resistive load always has a power factor of one. This is because the current and voltage waveforms are in phase in an AC circuit.