0
Class 1 Division 1 location is designated as an area where flammable volatile liquids or liquefied flammable gases are transferred from one container to another. An example of this would be at a gas station when you put gasoline into your vehicle.The area around the pumps is class 1 div. 1.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is cl PS current transformer?
CL of a CT is its accuracy class.. it is an approximate measure of the CT's accuracy. e.g. The ratio (primary to secondary current) error of a Class 1 (CL:1.0) CT is 1% at rated current
What is the value of the smallest division on an ammeter scale?
what is the value of the smallest division on a ammeter
What is the smallest primary voltage division on a analog multimeter?
0 is smallest primary voltage division
Class px ct?
Class PX is the definition in IEC 60044-1 for the quasi-transient CT formerly covered by Class X of BS-3938, commonly used with unit protection schemes. These are Protection CTs used for Earth fault protection. Knee point voltage is an important parameter for these type of CTs. Shaikh
RF amplifier of an AM receiver is normally biased in class a class b class c?
class C because Class C also provides better signal,rejects unwanted signal.class c
What type of fittings are allowed in a class 2 division 1 hazardous area?
what type of fittings are allowed in a class2 division 1 hazard area
Is a seal off required in a class 1 division 2 area?
yes
What is the DOT hazard class 4 division 1?
Class 4 division 1 (more properly called Division 4.1) is for flammable solids.
Class 4 division 1 Dot hazards?
Class 4 division 1 (more properly called Division 4.1) is for flammable solids.
Liquid fueled rocket motors are and example of a class 1 division 3 explosive?
Class 1 Division 3 explosive
What type of material is found in class 2 division 1?
DOT Class 2, Division 1 (more properly called Division 2.1) is for flammable gases.
What are class 1.1 materials?
Class 2 division 1, more properly called division 2.1, is for flammable gasses.
What type of material is found in DOT class 2 division 1?
DOT Class 2, Division 1 (more properly called Division 2.1) is for flammable gases.
What are Dot class 6 division 1 materials consist of?
DOT class 6 division 1 materials consist of poisonous materials.
What is class 4 division one in the DOT hazard?
Class 4 Division 1 (more properly called Division 4.1) is for flammable solids.
Class 4 division 1?
flammable solid
What is class 1 division 6 of the DOT hazard classification system?
Poisonous materials are found in DOT division 6.1.
