It may be an attempt to apply a "catch all" phrase as an answer, but a sawtooth generator is used to supply sweep. And sweep is used widely in electronics applications. One application might be in the search for signals in a given frequency band using a spectrum analyzer. That band, that group of frequencies, would have to be "swept" by the receiver. It would have to tune in the different frequencies in order and on a continuous basis. By applying a sawtooth wave to a voltage controlled oscillator (VCO) used as the local oscillator in a receiver, the frequency of the VCO could be swept up the spectrum from a starting point to an end point, and then it could be done all over again continuously. The correct sawtooth voltage to the VCO would enable the receiver to make pass after pass across the band under study, and the strength of a signal on a given frequency could be indexed and shown on a display.
The sawtooth wave provides a sweeping range which controls the time parameter in the base circuits.
It is definitely used in a turbo-generator
A wheel composed of a series of blades that is used to turn a generator is known as a turbine.
The general term generator is usually applied to the kind of generator that produces electricity, or electric power.
A square wave pulse generator is the most commonly used generator. It is mainly used in testing different equipment. It outputs square waves that varies between two levels, with a 50 percent duty cycle.
Advantage 1. Different waveform upto mhz freq. Can be generated 2. it can be used to generate square, sine, triangular and sawtooth waveforms 3. calibration is internal. Disadvantage They are usually not suitable for applications that need low distortion or stable frequency signals.
It can be used as a Sawtooth wave generator
The main application of a sawtooth generator in consumer electronics has been in CRT displays. To control the scanning of the electron beam, you need precise ramp input to the deflector coils, but you need to bring back the electron beam to the left side (top) of the display quickly to maximize brightness; hence, two sawtooth generators for the vertical and horizontal scanning. Of course, this is less common than it once was, since the advent of LCD and plasma displays.
What kind of question is that. What resistors, what circuit are you talking about?
The Sawtooth Grin was created in 1999.
The Sawtooth Grin ended in 2004.
Samoa sawtooth eel was created in 1959.
Sawtooth Mountains Wilderness was created in 1994.
The area of Sawtooth National Forest is 8,498.398 square kilometers.
Sawtooth National Forest was created on 1905-05-29.
Sawtooth National Recreation Area was created in 1972.
Lake Chelan-Sawtooth Wilderness was created in 1984.
The area of Sawtooth Mountains Wilderness is 130.05 square kilometers.