Answer The flywheel is connected to the crank shaft on the engine. It has teeth on it that the starter connects to to start the engine when the starter gear is energized. After the flywheel and before the transmission is the torque convertor. This is what pressurizes the transmission so that is it shifts into and between gears as the car is running. Good luck.
They are at different levels. The transmitter will help you to get started by the smart transmitter will help you with more advanced problems.
Different brakes and suspension. Towing package may include trailer light connector.
Yes, all golfs have a flywheel. Dependant on model the flywheel can weigh between 6 and 9kg.
Output of two wire transmitter in mA and Output of two three transmitter in volt
On the back of the engine, mounted between the engine and transmission, inside the bell housing. You cannot see the flywheel. The starter is connected to the flywheel when you start the engine.On the back of the engine, mounted between the engine and transmission, inside the bell housing. You cannot see the flywheel. The starter is connected to the flywheel when you start the engine.
The difference between a coded and non-coded transmitter is a coded transmitter will only transmit to your receiver. So if your planning on exercising around people who will be wearing transmitters you want a coded transmitter so you don't get there heart rate. If you are working out solo, get a non-coded transmitter.
The flywheel, also called a flexplate, is in between the engine and transmission.
One difference between an SC and an LC connector is that an LC connecter is smaller in size than an SC connector. Also, an LC connector is considered a latch connector, whereas an SC connector is considered to be a push-pull connector.
Its between the crankshaft & the clutch.
They are the same thing. A smart transmitter can be Hart, Fieldbus and in the case of Foxboro instruments FoxCom.
transmitter means to carry towards signal or panel & gauge means to indicate at on spot by clock.
To change the flywheel or flexplate you'll need to remove the engine, transaxle or both. The flywheel or flexplate is between the engine and transaxle and is easily changed once you have clear access to the space between them.