18436572 clock wise looking down at the cap, should be one lug with the #1 stamped into the cap 1357 are on the driverside of engine 1 being at the front of engine,2468 on passanger side 2 being at the front of engine
Not easily. The 4.7 uses a different trans, computer, wiring, etc.
No, a 2000 Dodge Durango is not equipped with a PTO.
yep but you need to take motor mounts and ecm and wiring
The distributor is synched or zeroed with the scan tool. It can not be done with a timing light.
The 2000 Dodge Durango 5.9L distributor spark plug wire firing order is 1, 8, 4, 3, 6, 5, 7, 2. The number one cylinder is at the front of the engine on the left side. The distributor rotates clockwise.
The distributor is set to 0 degrees with a scan tool. It can not be done with a timing light.
No, a 2000 Durango was not built with a cabin filter.
ten - tan
How to replace the inside Spectra Heater Core on a 2000 dodge durango??
The Dodge Durango was introduced in 1998, so this question cannot be answered. However, in the 2000 Durango.... The camshaft position sensor is located in the distributor on all 3.9L V-6 and 5.2/5.9L V-8 engines Camshaft Position Sensor REMOVAL Distributor removal is not necessary to remove camshaft position sensor Remove air cleaner assembly. Disconnect negative cable from battery. Remove distributor cap from distributor (two screws) Disconnect camshaft position sensor wiring harness from main engine wiring harness. Remove distributor rotor from distributor shaft. Lift the camshaft position sensor assembly from the distributor housing Camshaft Position Sensor INSTALLATION Install camshaft position sensor to distributor. Align sensor into notch on distributor housing. Connect wiring harness. Install rotor. Install distributor cap. Tighten mounting screws. Install air cleaner assembly. (this info from post on answers.com about cps on 2000 durango)
yes
how to reset security system in a 2001 dodge durango